491262

Renkforce RSD-1802 Manual

42
Zoom out
Zoom in
Previous page
1/121
Next page
42
Operating Instructions
English
Electric Connection
The electric connection should be made by a specialist.
To avoid short circuits and resulting damage to the SD tuner, the negative pole (earth) of the
vehicle battery must be disconnected during connection.
Only connect the negative pole of the battery when you have completely connected the system
and checked the connections.
You should only use a voltmeter or a diode test lamp for checking the voltage on the on-board
cables as normal test lamps consume excessive currents and can thus damage the electronic
system of the car.
When laying the cables, make sure that they are not squeezed or scoured on sharp edges. Use
rubber grommets for the feed-though points.
Connection to the speakers must be two-wire each. Insulate any open connection points. Make
sure that the cables are not damaged by sharp edges.
Only use speakers with sufficient load capacity (see “Technical Data”).
Observe that all speakers have the correct polarity - that is, that plus and minus marks match.
The connecting cables of the loudspeakers are usually coded: Some speaker manufacturers
indicate the (+) wire by means of an additional colour stripe, others use a corrugated cable for
the (+) terminal and a smooth one for the (-) terminal.
The system was designed for the operation at speaker impedances of at least 4 Ohm. Never
connect speakers with a lower impedance.
In most vehicles the cables for the electric connection and the connection of the speakers have been
laid directly to the slot.
If this is not the case, please make sure that any cables placed later are secured by the respective on-
board fuses (see vehicle operation manual).
… 42 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Renkforce RSD-1802 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Renkforce RSD-1802 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info