738526
4
Zoom out
Zoom in
Previous page
1/6
Next page
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the
technical status at the time of printing.
© Copyright 2015 by Conrad Electronic SE. V1_0215_02-ETS-Mkd
Installation site
a) General
• There should be no lights near the power outlet to prevent malfunction.
• The twilight sensor needs to be fully exposed and shall not be covered in any way.
• The arrow on the rating plate must face upward.
b) Indoor use
• The wall power outlet to which you connect the product must be located in an
indoorspacewithawindowinorderforthetwilightsensortodierentiatebetween
night and day.
• However, the power outlet should not be located directly next to the window to
avoid direct sunlight.
c) Outdoor use
Toensuretheproduct‘ssplashproofrating,youmustfulllthefollowing:
• Plug the product into an outdoor splash-proof power outlet.
• The power plug of the electric appliance you wish to connect to the product must
also be splash proof.
• Close the cover when no electric appliance is connected to the product.
Operation
• Turnotheelectricapplianceyouwishtoconnect.
• Plug the electric appliance into the power outlet on the product.
• Plug the product into a common household power outlet.
• Switch on the electric appliance.
• Select the desired mode using the set wheel. The arrow above the set wheel points
at the selected mode.
• To disconnect the electric appliance from the product, rst turn o the electric
appliance. Then unplug the product from the power outlet. Now you may unplug the
electric appliance from the product.
Some commercially available power adapters may not be connected to the
product due to its design.
Mode overview
Mode Function
OFF Theconnectedelectricapplianceisoconstantly.
ON The connected electric appliance is on constantly.
2Hrs
These modes allow you to manually shorten the switch-on time to 2, 4,
6, or 8 hours. The electric appliance turns on automatically in increasing
darkness.Unliketwilightmode,theproductturnsoautomaticallywhen
the countdown elapses.
4Hrs
6Hrs
8Hrs
DUSK-
DAWN
Twilight mode: The electric appliance turns on automatically in increasing
darkness. The electric appliance turns o automatically in increasing
light.
Ifyouselectadierentmodewhileaprogramisactive,theactiveprogram
is interrupted and replaced by the selected mode immediately.
If countdown mode is active and the ambient brightness increases, the
electricappliancewillturnobeforethecountdownelapses.
The most recently selected mode repeats daily.
LED status light
• The LED status light lights up constantly when the product‘s power outlet is
activated.
• The LED status light goes out when the product‘s power outlet is deactivated.
Maintenance and cleaning
• This product does not require maintenance. There are no user-serviceable
parts inside the product. Therefore, do never open/dismantle the product. Have
maintenanceandrepairsdonebyqualiedexpertsorrepairshopsonly.
• Do not use any aggressive cleaning agents, rubbing alcohol or other chemical
solutions as they can cause damage to the housing and malfunctioning.
• Never submerge the product in water or other liquids.
• Never point any water jet, such as that of a high-pressure cleaner, at the product.
• Disconnect the product from the power outlet and from the connected electric
appliance before cleaning.
• Tocleantheproduct,adry,softandcleanclothissucient.Donotapplytoomuch
pressure to the housing to prevent scratching.
• You can use a long-haired, soft and clean brush and a vacuum cleaner to remove
dust.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste.
At the end of its service life, dispose of the product according to the
relevant statutory regulations.
Youthusfullyourstatutoryobligationsandcontributetotheprotectionof
the environment.
Technical data
Operating voltage................................230 V/AC, 50 Hz
Connected load ...................................max. 1000 W
Output current .....................................5 A
Protection type ....................................IP44
Operating conditions ..........................-10 to +55 ºC, 0 – 90 % RH
Storage conditions..............................-10 to +55 ºC, 0 – 90 % RH
Dimensions (W x H x D)......................60 x 130 x 39 mm (without plug)
Weight ...................................................180 g
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Renkforce EMT446MD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Renkforce EMT446MD in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 0,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info