486358

Renkforce BSD-3023 Manual

58
Zoom out
Zoom in
Previous page
1/177
Next page
58
Operating Instructions
English
Electrical Connection
The electrical connection should only be performed by a specialist.
To prevent short circuits and the resulting damage to the device, the minus pole (earth) of the
vehicle battery must be disconnected during connection.
Only connect the battery’s minus pole again after connecting the device completely and
verifying the connection.
To inspect the vehicle voltage line voltage, only use a voltmeter or diode test lamp because
normal test lamps take up too high currents and, thus, may damage the vehicle electronics.
When placing the lines, observe that they are not crushed or scrape over sharp edges. Use
rubber sleeves in the penetration points.
Connection to the speakers must be two-wire each. Insulate any open connection points.
Only use speakers with sufficient load capacity (see “Technical Data”).
Observe that all speakers have the correct polarity - that is, that plus and minus marks match.
The speaker connection cables are usually encoded. Some speaker manufacturers mark the
(+)-line with an additional colour strip, while others use a grooved line for the (+)-pole, but a
smooth one for the (-)-pole.
The device was developed for operation with speaker impedances of at least 4 Ohm. Never
connect speakers with a lower impedance.
In most vehicles, the lines for electrical connection and connection of the speakers are already placed
up to the intended installation slot.
If this is not the case, ensure that the subsequently installed lines are secured by the respective
intended vehicle fuses (see vehicle operating manual).
… 58 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Renkforce BSD-3023 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Renkforce BSD-3023 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info