700339

Renegade RXA550 Manual

10
Zoom out
Zoom in
Previous page
1/32
Next page
10
AUDIO SIGNAL CABLES
WheninstallingtheaudiocablesbetweentheRCAoutputsoftheheadunitandtheRCAinputsoftheamplier,
the audio and power supply cables should, if possible, not be routed along the same side of the vehicle. We
recommend a separated installation, e.g. routing the power cable through the cable channel on the left side
and the audio cables through the cable channel of the vehicle on the right side or vice versa. This prevents
interferences due to crosstalk into the audio signal.
SIGNAL OUTPUTS TO CONNECT ADDITIONAL AMPLIFIERS
The input signal on the INPUT jacks (Fig. 1,6) will be routed in stereo to the output jacks OUTPUT (Fig. 1,5).
ThustheOUTPUTjackallowstheconnectionofaadditionalamplier.
INPUT SENSITIVITY
OPERATING ELEMENTS
TurntheGAIN(Fig.1,9)controlleroftheampliertotheMINposition.Thenturnthevolumecontrollerofthe
headunit to 80 - 90% of its full setting. Now turn GAIN clockwise until you hear some distortion. Then turn back
the GAIN slightly until you hear a cleaner sound.
VARIABLE HIGHPASS FILTER
Ifthe amplieris tobe usedfor mid-range/tweeterloudspeakers, setthe switchesCROSSOVER(Fig.1,3)
to HPF. Then set the desired cross-over frequency on the HPF controller (Fig.1,2). Thus to that only the fre-
quenciesabovethechosencross-overfrequencywillbeamplied.Thiseffectivelyminimizesdistortionsand
overloads at lower frequencies. A good point to start is at 125 Hz.
If you use loudspeakers (>20 cm) set CROSSOVER (Fig.1,3). to ”FULL”. In this case, the HPF controller are
without function (Fig.1,2).
PROTECTION CIRCUIT
ThePRT/PWRLED(Fig.1,1)litsupgreen,iftheamplierisinoperation.
ThePRT/PWRLED(Fig.1,1)litsupred,whentheamplierisoverheated,orashortcircuitoccursresp.atoo
low impedance load is connected to the speaker outputs. If this events, the internal built-in protection circuit
shutsdown theamplier automatically.Theampliershould workagain properlyafter youhave solvedthe
problems.
VARIABLE LOWPASS FILTER
If the amplier is used to drive a subwoofer, set the switch (Fig. 1,3) to „LPF“. Set the desired cross-over
frequency by using the controller (Fig. 1,4). Thus to that only the frequencies below the chosen cross-over
frequencywillbeampliedandthesubwooferplaysmoreprecisedandefcient.
SWITCHABLE BASS BOOST
SWITCHABLE TREBLE BOOST
By using the BASS BOOST switch (Fig.1,8) you are able to increase the bass enhancement by 6 or 12 dB.
Attention: Use the BASS BOOST wisely!
By using the TREBLE BOOST switch (Fig.1,7) you are able to increase the treble enhancement by 6 or 12 dB.
Attention: Use the TREBLE BOOST wisely!
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Renegade RXA550 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Renegade RXA550 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 4,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info