700359
8
Zoom out
Zoom in
Previous page
1/12
Next page
ENG
8
INTERCONNECTION
INSTALLATION
First connect the GND terminal ( 3 ) of the device to an appropriate ground connection at the chassis. To ensure a good connection, remove
dirt and dust from the connection point. A loose connection may cause malfunctions or interferences noise and distortion.
Use at least a 10 mm
2
cross-section for the power and ground connection cable. Suitable cable sets are available at the specialist shop.
Then connect the +12 V terminal ( 2 ) of the device with the battery by using an appropriate cable including an in-line fuse. This fuse
should be located very close to the battery; for safety reasons not more than 30 cm away. Only insert the fuse when the installation has
been accomplished.
Then connect the remote turn-on-wire from the head unit with the device‘s REM terminal ( 1 ). A cable with a cross-section of 0.5 mm
2
is
adequate.
Choose a suitable location for your device. The permanent temperature of the location should not be lower than 5°C and not higher than
50°C. Protect the device from moisture and humidity. Ensure that your device will not get loose during the drive and hurt someone in the
passenger cabin. Use therefor the included mounting brackets (4 x) and screws (8 x). Then use self-tapping screws (not included) from the
specialist trade, to fix the device in your vehicle.
Please observe not to damage any serial components of your vehicle (air bags, wires, gas tank etc.) during the installation of your device
by drilling or any other operations.
POWER SUPPLY AND TURN-ON-CONNECTION
The amplifier detects a voltage rise (6 Volts) with a so called ”DC Offset” over the connected input signal on the HIGH LEVEL input ( 5 ) when
the head unit will be switched on. Hence, the amplifier will also be turned on. As soon as the head unit will be turned off, the amplifier turns
also automatically off. In this case the turn-on connection at REM ( 1 ) is not needed, if the switch ( 6 ) is in position ON.
Note: The Auto Turn On-function ( 6 ) usually works with 90% of all head units, because they are equipped with ”High Power”-outputs. Only
with a few older and still existing head units the Auto Turn On-function is not working.
AUTO-TURN-ON FUNCTION
Fuse with a rating of 25 A ( 4 ). If the fuse is defective, please replace with an equivalent fuse.
FUSE
3 1
46 5 2
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Renegade RS800A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Renegade RS800A in the language / languages: English, German as an attachment in your email.

The manual is 1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info