587850
22
Zoom out
Zoom in
Previous page
1/32
Next page
It is only permitted to connect
one fresh air intake and one
adjacent room!
CAUTION
2. Carefully remove the insulation
behind the opening (Fig 9).
3. Break through the appropriate
opening (Fig 10).
4. Keep the ventilation pipes as
short as possible and lay them
in such as way as to minimise
the amount of bends.
5. The collars, screws, flexible /
folded spiral seam pipes and
insulation materials should be
provided by the customer.
The above items can be
obtained from specialist
suppliers(Fig 11).
8 Remove the cut-out
9
Carefully remove the insulation
10
Break through the opening
11
Attaching the pipe collar
Connection to adjacent room
The indoor unit can also be used
to cool an adjacent room through
a duct system, e.g. hidden behind
a suspended ceiling. The following
conditions must be met:
The rated cooling output of the
indoor unit must be sufficient
for both rooms.
An opening must be made
between both rooms to allow
the air to circulate.
The maximum pipe length of 7
m should not be exceeded.
In order to ensure that the air
is transported to the adjacent
room, close off 1 or 2 of the
four outlets on the cover. Stick
a black single-sided adhesive
fabric strip over the outlet
openings being covered. This
strip must be able to withstand
the effects of a continual air
flow.
Fresh air intake
Connection to adja-
cent room
Connections to adjacent room and
fresh air intake
Fresh air intake
As already mentioned, the indoor
unit can also be employed to suck
in and regulate the temperature of
fresh (outdoor) air in addition to
room air.
This is the preferred option for
rooms with a high rate of air
consumption.
Observe the regional
regulations concerning air
treatment.
Fit a collar with a nominal
diameter of 70 mm to the fresh
air intake.
The fresh air content should not
exceed 10 % of the nominal
air flow rate for the equipment.
The fresh air supply should
be controlled by an additional
speed-regulated fan.
The air at the outdoor air intake
should be sucked in through a
dust filter at a maximum rate of
2.5 m/s to prevent the ingress
of rain water.
The fan should be connected to
a separately protected electrical
supply (to be provided by the
customer).
REMKO SV
22
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO SV261 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO SV261 in the language / languages: English as an attachment in your email.

The manual is 3,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO SV261

REMKO SV261 User Manual - German - 32 pages

REMKO SV261 User Manual - Dutch - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info