726816
29
Zoom out
Zoom in
Previous page
1/120
Next page
2. Standard inlet temperature
Setting the standard inlet temperature takes place
in the same way - although using the right grey
slide control.
Fig. 34: Setting the standard inlet temperature
3. Set the standard outside temperature
1
Fig. 35: Set the standard outside temperature
The standard outside temperature [1] can be
changed for the user and the expert.
These parameters can be found in the level: “Set-
tings " heating/cooling "
Building adaptation".
Here, it is possible to set the standard outside tem-
perature to the respective value for heating and
cooling mode.
The standard outside temperature is only changed
once here for each active heating cycle. After
changing this parameter, the value is automatically
accepted with all active heating cycles.
For optimal configuration of the heating curve
parameters, the heating load calculation and/or
energy consumption must be taken into account.
Differences between the installed parameters and
the design of the actual building can cause the
heat pump to run inefficiently.
29
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO Smart-Control-Touch SQW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO Smart-Control-Touch SQW in the language / languages: English as an attachment in your email.

The manual is 5,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO Smart-Control-Touch SQW

REMKO Smart-Control-Touch SQW User Manual - German - 80 pages

REMKO Smart-Control-Touch SQW User Manual - Dutch - 124 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info