726816
28
Zoom out
Zoom in
Previous page
1/120
Next page
3.3 Setting the heating/cooling
operating mode
Heating curve heating cycle mode
The heating curve can be adjusted in three points,
according to the structure and location-related con-
ditions of the building:
Base point:
The base point corresponds to the minimum set
temperature of the heating water at an outside
temperature of 20 °C. If the heating is too cold at
relatively high outside temperatures (trans-sea-
sonal period), the base point should be set higher
.
Standard inlet temperature:
The standard inlet temperature corresponds to the
set temperature of the heating water at the
standard outside temperature in the building loca-
tion. If the heating is not warm enough at low out-
side temperatures, the standard inlet temperature
should be increased.
Standard outside temperature:
The standard outside temperature is dependent on
the regional location of the building and must be
set according to the region.
2
1
4
3
Fig. 32: Heating curve adjustment
1: Temperature of the heating water in °C
2: Inlet temperature heating curve
3: Return flow heating curve
4: Outside temperature in °C
For optimal configuration of the heating curve
parameters, the heating load calculation and/or
energy consumption must be taken into account.
Dif
ferences between the installed parameters and
the design of the actual building can cause the
heat pump to run inefficiently.
Setting the heating curve:
1. Base point
In this level, select the heating cycle to be changed
and select the parameter “Heating curve settings”.
Under the heating curve schematic, select the left
grey slide control and set to the desired tempera-
ture.
Fig. 33: Setting the base point
REMKO Smart-Control Touch
28
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO Smart-Control-Touch SQW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO Smart-Control-Touch SQW in the language / languages: English as an attachment in your email.

The manual is 5,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO Smart-Control-Touch SQW

REMKO Smart-Control-Touch SQW User Manual - German - 80 pages

REMKO Smart-Control-Touch SQW User Manual - Dutch - 124 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info