726585
27
Zoom out
Zoom in
Previous page
1/84
Next page
6 Installation
6.1 Preparations for installation
Removing the air inlet grill
NOTICE!
Installation should only be performed by author-
ised specialists.
1. Fold the air inlet grill forwards.
2. Remove the middle retainer by releasing the
two bars from the fastening.
3. Undo the lateral fastening screws and
remove the grill.
4. After installation, all parts that were removed
must be fitted again.
6.2
Installation of the indoor unit
Wall installation
The unit is attached by means of a wall bracket,
taking account of the air outlet side located
towards the top of the unit.
1. Mark the mounting points on the structurally
permissible building sections according to the
dimensions of the wall bracket.
2. If necessary
, remove the break out opening
of the housing.
3. Hook the unit on to the previously attached
bracket.
4. Connect the refrigerant piping, electrical
cables and condensate drainage line to the
indoor unit as described below
.
5. Hang the indoor unit onto the wall bracket by
tilting it back slightly and by pressing the
bottom part of the unit against the bracket.
6. Check again that the unit is level.
The wall bracket for the units must be attached
with suitable screws and anchors.
Ceiling installation
The unit is attached by means of the integrated
ceiling bracket, taking account of the air outlet side
located on the front of the unit.
1. Mark the mounting points on the structurally
permissible building sections according to the
dimensions of the wall bracket.
2. If necessary
, remove the break out opening
of the housing.
3. Hook the unit onto the four previously
installed screws/threaded rods.
4. Fit the unit such that it is attached 5 mm
lower in the connection area (air inlet) than
on the air outlet side!
5. Connect the refrigerant piping, electrical
cables and condensate drainage line to the
indoor unit as described below
.
27
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO RXT 525 DC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO RXT 525 DC in the language / languages: English as an attachment in your email.

The manual is 4,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO RXT 525 DC

REMKO RXT 525 DC User Manual - German - 84 pages

REMKO RXT 525 DC User Manual - Dutch - 84 pages

REMKO RXT 525 DC User Manual - French - 84 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info