726581
33
Zoom out
Zoom in
Previous page
1/84
Next page
8 Electrical wiring
8.1 General connection
and safety instructions
A protected power supply cable is to be connected
to the outdoor unit and a four-core control line with
a minimum cross-section of 1.5mm
2
. T
o avoid EMC
interference, only use shielded cable for this pur-
pose and connect the shielding on both sides.
DANGER!
All electrical installation work is to be performed
by specialist companies. Disconnect the power
supply when connecting the electrical terminals.
NOTICE!
The electrical connection for the units must be
made at a separate feedpoint with a residual
current device in accordance with local regula-
tions and should be laid out by an electrician.
W
e recommend using shielded wires for the
control lines.
n W
e recommend that a mains/repair switch be
installed near the outdoor unit.
n The terminal blocks for establishing the con-
nections are located on the side of the unit.
When the unit is installed, measurements can
be made from the front by removing the cover.
n If an optional condensate pump is used as an
accessory in conjunction with the unit, it may
be necessary to install an additional relay with
a higher contact rating after the switch-off con-
tact on the pump to switch off the compressor.
n The control lines used should comprise
shielded wire, if laid in areas exposed to strong
magnetic fields.
n Details concerning the electrical protection of
the system are provided in the technical data.
8.2 Connecting the indoor unit
Make the connection as follows:
1. Open the air inlet grill.
2. Loosen the switch cabinet's cover (
Fig. 38).
3. Feed the voltage-free cable through the edge
protection rings on the control box and clamp
the cable in the strain relief.
4. Then connect the cable in accordance with
the wiring diagram (see chapter “Electrical
wiring diagram”).
5. Connect the electrical plugs on the cover to
the mating connectors on the cassette. It is
not possible to incorrectly connect these.
6. Re-install all disassembled parts.
Fig. 37: Switch cabinet access
33
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO RVD 355 DC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO RVD 355 DC in the language / languages: English as an attachment in your email.

The manual is 5,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO RVD 355 DC

REMKO RVD 355 DC User Manual - German - 84 pages

REMKO RVD 355 DC User Manual - Dutch - 84 pages

REMKO RVD 355 DC User Manual - French - 84 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info