726584
26
Zoom out
Zoom in
Previous page
1/84
Next page
5.6 Oil return measures
If the outdoor unit is installed at a higher level than
the indoor unit, suitable oil return measures must
be taken. Usually
, an oil pump bend is installed for
every 7 metres of height difference.
1
A
B
2
Fig. 24: Oil return measures
AT: Outdoor unit
IT: Indoor unit
1: 1 x oil pump bend in suction pipe to outdoor
unit every 7 metres of height dif
ference,
radius: 50 mm
2: Max. 10-15 m
6 Installation
6.1
Unit installation
NOTICE!
Installation should only be performed by author-
ised specialists.
The unit is mounted with the cover facing down on
four threaded rods. T
ake into account the ceiling
grid and any other installations.
1. Use the dimensions of the ceiling cassette to
mark the fixing points for the threaded rods
on structural parts approved to support the
static load above the suspended ceiling
(Fig. 25).
2. Fit the indoor unit onto the threaded rods and
use the lower nuts to level the unit (
Fig. 26).
3. Adhere to a ceiling clearance of at least 30
mm. Connect the refrigerant piping, electrical
cables and condensate drainage line to the
indoor unit as described below
.
4. Check again that the unit is level.
5. The final task is to tighten the counternuts
and attach the cover
.
A
B
Fig. 25: Hooking in the unit
Indoor units
(all dimensions in mm)
Measure-
ment A
Measure-
ment B
RVD 355-525 DC 545 523
RVD 685-1055 DC 780 680
REMKO RVD series
26
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO RVD 1055 DC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO RVD 1055 DC in the language / languages: English as an attachment in your email.

The manual is 5,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO RVD 1055 DC

REMKO RVD 1055 DC User Manual - German - 84 pages

REMKO RVD 1055 DC User Manual - Dutch - 84 pages

REMKO RVD 1055 DC User Manual - French - 84 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info