587736
16
Zoom out
Zoom in
Previous page
1/28
Next page
16
Sun:
The plate fin exchanger (condenser) on the outdoor part
is a heat-emitting component. Direct sunlight also in-
creases the temperature of the plate fins and reduces
the amount of heat expelled by the plate fins exchanger.
If possible, the outdoor part should be installed on the
north side of the respective building.
A small structure should be set up to provide shade for
the unit and protect it from the sun if necessary. How-
ever, it must not be allowed to interfere with the flow of
hot air being released from the unit.
Rain:
If the unit is set up on the ground or a roof, there must
be at least 10 cm (measurement X in the illustration be-
low) between it and the surface.
A base console can be purchased as an accessory.
Setup locations for the outdoor part
The unit must be set up on a surface that is level,
smooth and solid. The unit must also be secured
against tipping over.
The outdoor part can either be set up outside or inside a
building. If it is set up outside, follow these instructions
to protect the unit from weather conditions.
Snow:
If the unit is also operated in winter, the outdoor part
should be mounted on the wall.
The unit should be installed at least 20 cm above the
expected snow level to prevent snow from entering the
outdoor part.
A base console can be purchased as an accessory.
Wind:
If the unit is operated primarily in windy areas, make
sure that the hot air current being released from the unit
is flowing in the primary wind direction.
If this is not possible, you should provide protection from
the wind. Make sure that the wind protection does not
adversely affect the flow of the air to the unit.
Wind
Setup inside buildings:
If the outdoor part is set up inside a building, observe
the following.
àMake sure that air can be freely supplied from the
outside, if possible through air openings opposite the
unit that are sufficiently large.
àEnsure that there is adequate soundproofing to pre-
vent excessive noise in residences.
àNever block or shut the intake grille.
àObserve the static and other structural engineering
regulations and requirements for the building.
àDo not set up the unit in areas with lots of dust or ag-
gressive air.
These safety zones ensure that air can flow freely in
and out of the unit, that maintenance and repair work
can be performed and to protect the unit from damage.
B
C
B
A
A B C
RKS 327 H IT 300 200 1000
RKS 335 H IT 300 200 1000
RKS 350 H IT 300 200 1000
RKS 371 H IT 300 200 1500
The following chart provides the minimum distances
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO RKS327H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO RKS327H in the language / languages: English as an attachment in your email.

The manual is 1,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO RKS327H

REMKO RKS327H User Manual - German - 28 pages

REMKO RKS327H User Manual - Dutch - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info