726614
36
Zoom out
Zoom in
Previous page
1/48
Next page
10.2 Fault analysis
Error code FE: Addressing conflict
The DIP switch set-
ting was changed
on the outdoor unit
YES
Switch off the power
supply to the
system, switch the
DIP switch setting
on the outdoor unit
back to factory set-
tings, switch on
system again,
wait 8 minutes
Outdoor unit
MVV 1200 DC
ON
1
2
SW3
Outdoor unit
MVV 1600-2000 DC
ON
1
2
SW3
3
NO
Has manual
addressing taken
place via the
infrared remote con-
trol?
NO
YES
Carry out manual
addressing again
(see chapter
"Addressing the
individual indoor
units”)
Error code E0: Mode conflict
Are all indoor units set to the same operating
mode?
NO
Set all indoor units to the same operating mode
YES
Is the communication line correctly wired?
NO
Correctly wire communication line
YES
Has shielded cable been used?
NO
Use shielded cable
YES
Is a fixed resistor (120 Ohm) installed on the
last indoor unit in the series?
NO
Install fixed resistor (120 Ohm) on the last
indoor unit in the series
YES
Is the power supply to all units OK?
NO
Ensure correct power supply
YES
Check the circuit board on the indoor unit or
outdoor unit and replace if necessary
REMKO MVW series
36
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO MVW 222 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO MVW 222 in the language / languages: English as an attachment in your email.

The manual is 3,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO MVW 222

REMKO MVW 222 User Manual - German - 48 pages

REMKO MVW 222 User Manual - Dutch - 48 pages

REMKO MVW 222 User Manual - French - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info