726595
32
Zoom out
Zoom in
Previous page
1/68
Next page
8 Electrical wiring
8.1 General connection
and safety instructions
For the MVV 1200-2000 DC units, an electrical
supply cable must be laid as a power supply to the
outdoor unit and indoor units, as well as a 3-core
control line from the indoor units to the outdoor
unit.
W
e recommend that control lines are used with a
minimum cross-section of 0.75 mm².
DANGER!
All electrical installation work is to be performed
by specialist companies. Disconnect the power
supply when connecting the electrical terminals.
NOTICE!
The electrical connection for the units must be
made at a separate feedpoint with a residual
current device in accordance with local regula-
tions and should be laid out by an electrician.
We recommend using shielded wires for the
control lines.
8.2 Outdoor unit connection
Before you start to connect, note the following
instructions:
n Customers should install a terminal box in the
vicinity of the outdoor unit. W
e recommend
using a main/repair switch (Figure 9).
n The power supply to the indoor units takes
place through a separate supply line to the
indoor units.
n Details concerning the electrical protection of
the system are provided in the technical data.
Observe the required diameters!
n If the outdoor unit is installed on a roof, ensure
it is protected against lightning strikes.
Proceed as follows to connect the line:
1. Remove the side panel at the connection.
2. Choose the cable cross-section in accord-
ance with the relevant specifications.
3. Feed both cables through the edge protec-
tion rings on the fixed connection panel.
4. Connect the control line to the corresponding
terminals.
5. Fix the line in the strain relief and re-
assemble the unit.
Check all plugged and clamped terminals to
verify that they are seated correctly and make
permanent contact. T
ighten as required.
Fig. 27: Outdoor unit connection
REMKO MVV...DC
32
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO MVV 1200 DC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO MVV 1200 DC in the language / languages: English as an attachment in your email.

The manual is 3,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO MVV 1200 DC

REMKO MVV 1200 DC User Manual - German - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info