726593
42
Zoom out
Zoom in
Previous page
1/68
Next page
Error E8: Condenser fan speed control not working
Switch off, wait 2 minutes
and then switch on again. Is
the error still present?
NO
The unit operates normally.
YES
Switch off; rotate the con-
denser fan manually
. Does
it move easily?
NO
Determine the cause and
rectify the error
.
YES
Check the electrical con-
necting lines to the motor
.
Are these correctly imple-
mented?
NO
Replace the connections.
YES
Replace the control board.
NO
Check the output voltage on
the control board (see
annex). Is voltage available
to the output?
YES
NO
Replace the fan motor.
Check the DC motor (the control unit is installed in the motor)
Measure the voltage between terminals 1-3 and 4-3 on the plug when the unit is in standby mode. Compare
the measured voltage with the table below
. If the values do not match, the control board must be replaced.
1 3 4 5 62
Terminal Colour Voltage
1 Red 140 V~380 V
2 --- ---
3 Black 0 V
4 White 13.5-16.5 V
5 Yellow 0~6.5V
6 Blue 15V
REMKO MVT series
42
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO MVT 1053 DC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO MVT 1053 DC in the language / languages: English as an attachment in your email.

The manual is 4,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO MVT 1053 DC

REMKO MVT 1053 DC User Manual - German - 78 pages

REMKO MVT 1053 DC User Manual - Dutch - 68 pages

REMKO MVT 1053 DC User Manual - French - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info