726601
38
Zoom out
Zoom in
Previous page
1/48
Next page
Error code E1: Communication error between indoor unit and outdoor unit
Switch off power to the system for 1 minute, re-
establish power supply
, start system
YES
Is the communication line correctly wired?
NO
Correctly wire communication line
YES
Has shielded cable been used?
NO
Use shielded cable
YES
Is a fixed resistor (120 Ohm) installed on the
last indoor unit in the series?
NO
Install fixed resistor (120 Ohm) on the last
indoor unit in the series
YES
Is the power supply to all units OK?
NO
Ensure correct power supply
YES
Check the circuit board on the indoor unit or
outdoor unit and replace if necessary
Error code E2: Fault with T1 probe, ambient air
Is the probe correctly mounted on the circuit
board?
NO
Correctly mount the probe on the circuit board
YES
Is the probe visibly damaged?
YES
Replace probe
NO
Are the probe resistance values OK?
(
Ä
on page 41)
NO
Replace probe
YES
Replace indoor unit circuit board
REMKO MVD series
38
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO MVD 222 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO MVD 222 in the language / languages: English as an attachment in your email.

The manual is 3,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO MVD 222

REMKO MVD 222 User Manual - German - 48 pages

REMKO MVD 222 User Manual - Dutch - 48 pages

REMKO MVD 222 User Manual - French - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info