587594
11
Zoom out
Zoom in
Previous page
1/24
Next page
11
Troubleshooting
This unit has been designed based on state-of-the-art manufacturing methods and it has been tested repeatedly to
ensure that it is working properly. However, should problems occur, refer to the following list.
* *
Before any work on the units is performed, they must be disconnected from the power
supply (fuse or repair switch) and secured against being inadvertently switched on!
Should the unit still not work after performing these functional checks, please contact the closest dealer or
REMKO GmbH & Co KG. directly.
Problem Possible cause Check Remedy
The unit does not start
or it switches itself off
automatically.
Power failure, power too low Are all other electrical components
working?
Check current and wait for the device to start
again
Power fuse / power supply defec-
tive
Are all currents for lighting func-
tional?
Replace power fuse /
Switch on main switch
Power supply line damaged Are all other electrical components
working?
Maintenance by authorised service centre
Amount of time waited after
switching unit on was too short
Did approx. 5 minutes elapse after
restarting?
Plan for longer waiting periods
Operating temperature too low /
too high
Are the fans on the indoor unit and
outdoor unit working?
Pay attention to temperature ranges of in-
door unit and outdoor unit
Excess current caused by thun-
derstorms
Was there recently lightning in the
region ?
Switch the system off and then back on again /
Maintenance by authorised service centre
Problem with the external conden-
sation pump
Did the pump switch off due to a
malfunction?
Check pump and clean if necessary
Sensors that are defective or not
properly attached
Is the indoor unit displaying an er-
ror message?
Maintenance by authorised service centre
The indoor unit is not
responding to the re-
mote control.
Timer set to “ON” Is the timer set? Clear programming and wait for the unit to
start
Polarity of batteries incorrect after
replacement
Is the polarity correct? Insert batteries with the correct polarity
Transmission distance too great /
reception blocked
Is there a transmission signal when
the button is pressed?
Reduce distance to under 7 m and change
location
Remote control defective Does the unit work in manual
mode?
Replace remote control
Too much direct sunlight on the
receiver or transmitter
Does the unit work in the shade? Place the transmitter or receiver in the
shade
Electromagnetic fields are disrupt-
ing transmission
Does the unit work after potential
causes of disruption have been
eliminated?
No signal transmission when sources of dis-
ruption are operated simultaneously
Remote control buttons stuck /
two buttons pressed at once
Does the symbol appear on the
display?
Unstick button / only press one button
Dead batteries in the remote con-
trol
Are the batteries new? Is the dis-
play incomplete?
Insert new batteries
Temperature setting too high Is the selected temperature above
room temperature?
Reduce selected temperature
The device is either
not cooling at all or
only a little bit.
Filter is dirty/ intake / outlet open-
ing is blocked by foreign bodies
Have the filters been cleaned? Clean filters
Windows and doors are opened /
increased amount of warm air or
cold air
Have there been changes in de-
sign or use?
Close the windows and doors / mount addi-
tional systems
Cool mode is not set Does the Cool symbol (COOL)
appear on the display?
Correct the unit settings
Plate fins of the outer unit are
blocked by foreign bodies
Is the fan of the outdoor unit working,
are the plate fin exchangers moving
freely?
Check the fan or winter control mechanism,
reduce air resistance
Cooling cycle is not leak proof Is there a build-up of frost visible
on the plate fin exchangers of the
indoor unit?
Maintenance by authorised service centre
Condensation water is
leaking from the indoor
unit.
The drainage pipe of the conden-
sation collector is blocked / dam-
aged
Can condensation flow freely? Clean the drainage pipe and the condensa-
tion collector
External condensation pump or
float regulator is defective
Is the collector filled with water and
the pump is not working?
Have pump checked by authorised service
centre
Thermal or wind load has in-
creased
Have there been changes in de-
sign or use?
Take corresponding measures to decrease
the thermal or wind load
Heat cannot be expelled Is the fan on the outdoor unit work-
ing?
Check the fan / winter regulation mechanism
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO ML680 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO ML680 in the language / languages: English as an attachment in your email.

The manual is 1,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO ML680

REMKO ML680 User Manual - German - 28 pages

REMKO ML680 User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info