726561
19
Zoom out
Zoom in
Previous page
1/28
Next page
9 Troubleshooting and customer service
The unit has been manufactured using state-of-the-art production methods and has been tested several
times to ensure that it works properly
. If malfunctions should occur, please check the unit as detailed in the
list below. Please inform your dealer if the unit is still not working correctly after all the function checks have
been performed.
Operational malfunctions
Fault description Cause Remedy
The unit does not start or switches
itself of
f.
Master switch off. Switch on the master switch.
Power failure Check voltage and if neces-
sary wait until turned on again
Defective mains fuse Arrange to have exchanged
Power supply defective Repair by specialist firm.
Operational temperature range too
low or exceeded.
Observe operational tempera-
ture range 16 to 35 °C.
Internal reservoir full. Empty reservoir.
The ambient temperature of the
unit lies outside the operating
range (16 to 35 °C).
Do not operate the unit outside
the operating range.
The unit does not work or works at
reduced cooling capacity
.
Exhaust air hose kinked, extended,
routed downwards or blocked.
Ensure that there is a clear
path for the exhaust air.
Filter contamination, inlet and/or
outlet blower openings blocked by
foreign bodies.
Clean filter.
Minimum clearances too small. Observe minimum clearances.
Windows and doors open/heat load
was increased.
Close doors and windows/
reduce heat load.
Negative pressure in the installa-
tion room whilst the unit is oper-
ating with wall pass-through.
Balance out pressure in the
installation room.
"Cooling" operating mode is not
selected.
Set "Cooling" operating mode.
Unit will be switched by means of
the timer function.
Press "I/0" key again.
Temperature setting too high. Reduce temperature.
Overvoltage due to local lightning
strike.
Switch unit off and separate
from the power supply for 5
mins., then start anew
.
The unit does not respond to the
infra-red remote control.
Batteries in the remote control are
empty or the distance to the
receiver is too great.
Insert new batteries/reduce
distance.
After battery exchange, incorrect
polarity of batteries.
Insert the batteries with the
correct polarity
. Observe
marking.
19
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO MKT 255 Eco S-Line at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO MKT 255 Eco S-Line in the language / languages: English as an attachment in your email.

The manual is 2,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO MKT 255 Eco S-Line

REMKO MKT 255 Eco S-Line User Manual - German - 28 pages

REMKO MKT 255 Eco S-Line User Manual - Dutch - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info