587985

REMKO KWG950 Manual

23
Zoom out
Zoom in
Previous page
1/60
Next page
Wind
3 Wind protection
20 cm
Snow
4 Minimum distance to snow
Sun
The air-cooled condenser is a heat-
dissipating component in cooling
mode.
Direct sunlight also increases the
temperature of the fins and thus
reduces the heat dissipation of the
fin heat exchanger.
The unit should be set up on the
north side of the respective build-
ing, if possible.
On-site shading should be set up
as required.
A small roof suffices.
The emerging hot air flow, how-
ever, must not be influenced by
the measures.
Wind
If the unit is primarily installed
in windy regions, make sure that
the emerging hot air flow is dis-
sipated in the main wind direction.
If this is not possible, install wind
protection on site (Fig 3).
Make sure that the wind protec-
tion does not interfere with the air
supply of the unit.
Snow
In areas with high snowfall, the
unit should be mounted onto a
wall.
It should be mounted at least 20
cm above the expected snow-
fall height to prevent snow from
penetrating into the outdoor unit
(Fig. 4).
Setup inside the building
■
Provide a means of sufficient
heat dissipation if the outdoor
unit is to be installed in a cellar,
attic, utility rooms, or halls (Fig.
5).
■
Install an additional fan that
has the same air volume flow
rate of the outdoor unit to be
set up in the room and that can
compensate additional pressure
losses through air ducts
(Fig. 5).
■
Observe the static and other
construction
regulations and conditions in
regard to the building and pro-
vide sound insulation if neces-
sary.
■
Guarantee a continuous, un-
hindered air supply from the
outside, possibly using oppos-
ing, sufficiently large air open-
ings (Fig. 5).
Due to ambient influences,
such as rain, sun, wind, and
snow, the generated cooling or
heating capacity will change.
NOTE
Hot air
Cold
fresh air
Light
shaft
Chiller
Hot air
Light
shaft
Additional
fan
5 Installation inside the building (cooling mode)
23
… 23 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO KWG950 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO KWG950 in the language / languages: English as an attachment in your email.

The manual is 7,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO KWG950

REMKO KWG950 User Manual - German - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info