587985
22
Zoom out
Zoom in
Previous page
1/60
Next page
Lift
Min.
2000 mm
Tension point
Cross beam wider than the unit width
2400 mm
Tension point
Cross beam wider
than the unit width
Wall breakthroughs
We recommend that you insu-
late the inside of the hole or use
a PVC pipe to prevent damage
to the lines.
After mounting, close off the
wall breakthrough on site with
suitable sealing compound. Do
not use materials containing
cement or lime!
Mounting materials
The unit is attached to the floor
using vibration dampers (acces-
sory). When fastening the unit to
the wall, particularly observe the
load capacity of the bracket and
the wall.
Selection of the installation
site
The unit is designed for outdoor,
horizontal, upright installation. The
installation site of the unit must
be horizontal, even, and firm. In
addition, the unit must be secured
against tipping.
The unit can be installed both
outside and inside a building.
During outdoor installation, ob-
serve the following notices regard-
ing the protection of the unit
against the effects of weathering.
Definition of the
danger zone
Only authorised and trained
personnel may have access to the
unit. If unauthorised personnel
could enter the danger zones, they
must be labelled with correspond-
ing signs / barriers, etc.
The outer danger zone sur-
rounds the unit with at least
2 m, measured from the unit
housing.
The outer danger zone can dif-
fer as a result of the setup. The
specialist company performing
the installation is responsible for
this matter.
The inner danger zone is
located inside the machine
and can be accessed only
using corresponding tools.
Unauthorised persons must not
access this danger zone!
Rain
In case of installation onto the
floor or roof, there must be a mini-
mum floor clearance of 10 cm.
In the case of units for cooling and
heating (heat pump function only),
a raised installation increases the
generated heating capacity.
REMKO KWG
22
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO KWG950 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO KWG950 in the language / languages: English as an attachment in your email.

The manual is 7,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO KWG950

REMKO KWG950 User Manual - German - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info