587908
6
Zoom out
Zoom in
Previous page
1/44
Next page
6
REMKO GPM
Unit description
Unit definitions
According to EU directives, the
units are defined as:
“Gas hot air heaters without
draught diverters with a fan
upstream of the heat exchanger”.
The units are fully automatic,
direct-fired hot air heaters for wall
and ceiling mounting.
They can be fired with natural gas
or LPG.
The units are used for constant or
temporary heating of closed and
open rooms, e.g. in:
Halls, workshops, greenhouses,
storage rooms, etc.
Unit classification
The units are classified by the
European standards EN 437 and
EN 1020 according to:
Gas category:
Classification of the types of
gases with which the units can be
operated.
For Germany DE II2ELL3B/P
Type of gas:
The burner can be operated with
gases of the second family (natural
gas groups H and L) and with
gases of the third family (butane
and propane).
Type of gas appliance:
Classification according to options
for discharge of combustion
products and supply of combustion
air. (Room sealed/non-roomsealed)
For further information, see
chapter “Installation of chimney
duct and combustion air supply
pipe”.
Unit design
The outside housing of the units
is made of coated sheet steel for a
long useful life.
The outlet air grille(s) is/are
located at the front.
To ensure optimal hot air
distribution in the installation
room, the horizontal fins of the
air outlet grille can be adjusted
manually.
The circulation air fan(s) with
outlet grille, exhaust fume
discharge and combustion
air supply connections, gas
connections, electric cable lead-
throughs and plug connector for
mains connection are located at
the rear of the unit. Located on the
right side behind the inspection
door are the components
necessary for control and safety
such as
- the electrical circuit with wiring
- the control electronics
- the gas valve
- the modulating gas burner
The combustion chamber with
heat exchanger is located inside
the unit, directly in the circulation
air flow.
The combustion chamber is made
completely of Inox stainless steel
AISI 430.
Inox stainless steel AISI 441 is used
for the heat exchanger for higher
resistance to corrosion due to
moist vapours.
The special shape and large surface
of the combustion chamber and
heat exchanger ensure high
efficiency and a long service life.
The gas burner is also made
completely of specially machined
stainless steel.
Function of the units
GPM series modulating gas
wall heaters were developed for
heating rooms in industrial and
commercial premises.
The electronic control of the units
continuously regulates the heat
output between minimum and
maximum depending on the actual
heat demand.
Efficiencies of up to 94% can be
achieved with the premixing and
modulating technology.
The nominal heat output of the
REMKO GPM series is between
11.8 and 71.5 kW.
They essentially consist of the
combustion chamber with heat
exchanger and circulation air
fan(s).
The ambient air is sucked in by
the fan(s) and flows efficiently
via the burner chamber with heat
exchanger.
The combustion chamber is heated
by the gas burner and heats the
passing flow of air.
The air heated in this way is blown
out the front of the unit via an
adjustable air outlet grille.
Correct operation of the unit is
only possible with a connected
temperature control, e.g. ATR-6
(accessory).
The units are not suitable for
domestic heating or similar.
NOTE
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO GPM 55 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO GPM 55 in the language / languages: English as an attachment in your email.

The manual is 4,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO GPM 55

REMKO GPM 55 User Manual - German - 44 pages

REMKO GPM 55 User Manual - Dutch - 44 pages

REMKO GPM 55 User Manual - French - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info