794468
15
Zoom out
Zoom in
Previous page
1/28
Next page
15
Electrical wiring
The units are operated with
230 V 50 Hz alternating current
The electrical
connection is made
using a built-in
mains cable with
earthed safety plug
Extensions to the connection
cable may only be carried out
by authorised electricians,
subject to the length of
the cable, connected load
of the unit and taking into
consideration how the unit is
used at its location
Switching the units on
Connect the unit's power plug
to a properly installed mains
socket
Press the power key []
Use the [] key to select the
(min/max) air volume
The electrical connection to the units
must be made at feed-points with
residual current devices in accordance
with VDE 0100, Section 704.
When installing the units in
extremely damp environments such
as laundry rooms, showers etc., the
unit must secured with a residual
current device provided by the
customer in accordance with the
regulations.
NOTE
In room temperatures
below
10 °C
and relative
humidity below
40 %
,
economical use of the unit can
no longer be guaranteed.
NOTE
When the units are connected
to the power supply, they beep
quickly and the displays flash
once.
NOTE
Adjusting the humidity level
The unit’s dehumidification power
is entirely dependent on the
conditions inside the room, the
room temperature, the relative
humidity and observance of the
notes in the “Set-up” chapter.
The higher the room temperature
and relative air humidity, the
higher the dehumidification power.
A relative humidity of around
45 to 60 % is recommended for
living rooms.
However, the air humidity
should not exceed 40 to 45 % in
warehouses, archives, etc.
Unit initial settings:
Fan speed = min.
Humidity = 60 % RH
Use the [] buttons to select
the required humidity (% RH)
The set value is shown on
the display [] for around
10 seconds
The humidity level can be
adjusted in 5 % steps
from 30 - 90 % RH
In normal operating mode, the
display [] shows the current
humidity level in % RH
The display [] shows the
current room temperature
in °C or °F
The display is changed over
using the [] key
All cable extensions must only
be used in fully un-reeled or
reeled off condition.
CAUTION
!
The units are only permitted
to be operated with the outlet
grill clear in order to prevent
overheating.
CAUTION
!NOTE
At a humidity of < 30 %,
the “LO” indicator is shown
and, at > 90 %, the “HI” is
shown on the display [].
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO ETF-460 Eco at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO ETF-460 Eco in the language / languages: English as an attachment in your email.

The manual is 3.28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO ETF-460 Eco

REMKO ETF-460 Eco User Manual - German - 28 pages

REMKO ETF-460 Eco User Manual - Dutch - 28 pages

REMKO ETF-460 Eco User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info