717067
37
Zoom out
Zoom in
Previous page
1/64
Next page
11 Troubleshooting and customer service
11.1 Troubleshooting and customer service
The unit and components are manufactured using state-of-the-art production methods and tested several
times to verify their correct function. However, if alarms should occur, please check the functions as detailed
in the list below. For systems with an indoor unit and outdoor unit, refer to the chapter "Troubleshooting and
customer service" in both operating manuals. Please inform your dealer if the unit is still not working correctly
after all function checks have been performed!
Operational malfunctions
Malfunction Possible causes Checks Remedial measures
The unit does not start or
switches itself off
Power failure, under-
voltage, defective mains
fuse / main switch in
OFF position
Does all other electrical
equipment function cor-
rectly?
Check the voltage and if
necessary, wait for it to
come back on
Damaged power supply Does all other elec.
equipment function cor-
rectly?
Repair by specialist firm
Wait time after switching
on is too short
Have approx. 5 minutes
elapsed since the
restart?
Schedule longer wait
times
Temperature outside
operating range
Are the fans in the indoor
unit and outdoor unit
working correctly?
Observe temperature
ranges of indoor unit and
outdoor unit
Electrical surges caused
by thunderstorms
Have there been light-
ning strikes in the area
recently?
Switch off the mains
breaker and switch it
back on. Have it
inspected by a specialist
Malfunction of the
external condensate
pump
Has the pump shut down
due to a malfunction?
Check and if necessary
clean the pump
The unit does not
respond to the remote
control
Transmission distance
too far / receiver affected
by interference
Does the indoor unit
beep when pressing a
key?
Reduce the distance to
less than 6 m or change
position
Defective remote control Is the unit running in
manual mode?
Replace the remote con-
trol
Receiver or transmitter
unit exposed to exces-
sive solar radiation
Does it function correctly
in the shade?
Place the receiver and/or
transmitter unit in the
shade
Electromagnetic fields
are interfering with trans-
mission
Does it function after
removing potential
sources of interference?
Signal is not transmitted
when interference
sources are operational
Key in remote control
jammed / two buttons
pressed at same time
Does the “Transmitting”
symbol appear on the
display?
Release the key / only
press one key
Batteries in remote con-
trol are flat
Have new batteries been
inserted? Is the display
incomplete?
Insert new batteries
The unit works at
reduced or no cooling
capacity
Filter is dirty / air inlet /
outlet opening is blocked
by debris
Have the filters been
cleaned?
Clean the filters
37
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REMKO BL353 DC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REMKO BL353 DC in the language / languages: English as an attachment in your email.

The manual is 4,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of REMKO BL353 DC

REMKO BL353 DC User Manual - German - 64 pages

REMKO BL353 DC User Manual - Dutch - 64 pages

REMKO BL353 DC User Manual - French - 64 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info