616906
8
Zoom out
Zoom in
Previous page
1/160
Next page
8
• Themeshpanelishingedandcanbeswungopenwhenthechamberis
removed from the clipper.
• Ensurethemeshpanelisdrybeforere-usingtheclipper.
• We recommend oiling the blades after cleaning with a little sewing machine
oil.
, WASHABLE CLEANING
, NOTE: Only the blades on this clipper and the mesh panel of the vacuum
chamber can be washed under running water.
To remove the blades ensure the unit is o. Grab underneath the blade with
your thumb and push the top of the blade away from the clipper.
Use enough force to move the blade o the retaining snaps and rotate the
blade o the bottom tab. Pull the blade away from the clipper.
To reattach once the blades are cleaned and dry, align the bottom of the
blade with the bottom blade housing tab and push down onto the retaining
snaps until the blade clicks into place.
Do not run the entire unit under the tap, only the blade set is meant to be
submerged in water.
Place a few drops of cutter or sewing machine oil onto the blades. Wipe o
excess oil.
BATTERY REMOVAL
The battery must be removed from the appliance before it is scrapped.
The appliance must be disconnected from the supply mains when removing
the battery.
Ensure the clipper is discharged of all power.
Remove vacuum chamber and blade.
Using a small screwdriver, remove 3 screws top of clipper where the vacuum
chamber was.
Using a small screwdriver, remove 2 screws bottom of unit near the back
(plug end).
Pry the top housing starting from the back (plug end). There are snaps
helping to hold down the housing at the side grips on both sides. Once the
snaps are disengaged then rotate housing up this will allow the panel to be
removed o the latches near the front (blade end).
The PCB and batteries are located underneath this panel.
Cut or break the wire stamps on the both end of the batteries and remove
the batteries.
The battery is to be disposed of safely.
ENGLISH
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Remington HC6550 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Remington HC6550 in the language / languages: All languages as an attachment in your email.

The manual is 2,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info