805749
39
Zoom out
Zoom in
Previous page
1/76
Next page
Tab.35 Checking/setting values for O2 at part load for BREEAM with
G20 (H gas)
Values at part load for G20 (H gas) BREEAM O2 (%)(1)(2)
Quinta Ace 135 5.9(1) - 6.3
Quinta Ace 160 6.5(1) - 6.9
(1) Nominal value
(2) These values are only applicable when the fan speeds have been set
for BREEAM.
Tab.36 Checking/setting values for O2 at part load for G30/G31
(butane/propane)
Values at part load for G30/G31 (butane/propane) O2 (%)(1)
Quinta Ace 135 5.4(1) - 5.7
Quinta Ace 160 5.4(1) - 5.7
(1) Nominal value
Tab.37 Checking/setting values for O2 at part load for BREEAM with
G30/G31 (butane/propane)
Values at part load for G30/G31 (butane/propane)
BREEAM
O2 (%)(1)(2)
Quinta Ace 135 7.1(1) - 7.4
Quinta Ace 160 6.9(1) - 7.2
(1) Nominal value
(2) These values are only applicable when the fan speeds have been set
for BREEAM.
Caution
The O2 values at part load must be higher than the O2 values at
full load.
3. If the measured value is outside of the values given in the table,
correct the gas/air ratio.
4. Use adjusting screw B to set the percentage of O2 for the gas type
being used to the nominal value. This must always be between the
highest and lowest setting limit.
7.3 Final instructions
1. Remove the measuring equipment.
2. Screw the cap on to the flue gas measuring point.
3. Seal the gas valve unit.
4. Put the front casing back.
5. Heat up the central heating system to approximately 70°C.
6. Switch the boiler off.
7. Vent the central heating system after approx. 10 minutes.
8. Turn on the boiler.
9. Check the water pressure. If necessary, top up the central heating
system.
Fig.49 Location of adjusting screw B
AD-0000140-02
2
1
B
7 Commissioning
7701838 - v.09 - 10122021 39
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Remeha Quinta Ace 160 - T Control at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Remeha Quinta Ace 160 - T Control in the language / languages: English as an attachment in your email.

The manual is 3.13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info