805756
5
Zoom out
Zoom in
Previous page
1/44
Next page
1 Safety
1.1 Personnel qualification
The installation and maintenance of the appliance must be performed by
a qualified technician in accordance with local and national regulations.
Only approved and certified technicians are allowed to work on the
refrigerant circuit.
Installation and maintenance performed by under qualified technicians
(where applicable) will void the warranty of the product.
1.2 General safety instructions
Danger
To prevent (possible) personal injury, death, or damage to the
device or property:
Make sure that you know and obey all safety instructions and safety
provisions of the device.
Obey local safety rules and regulations.
When performing maintenance or any other work, disconnect the device
from the power supply and wait at least 10 seconds before you start
working on it.
The refrigerant circuit of the heat pump must be controlled by certified
staff, according to regulation EC 517/2014, at least every twelve
months, in order to check if the system is leak proof. When the device is
equipped with the leak detection option, inspections can take place at 24
month intervals.
1.3 Water quality requirements
The water quality of the heating circuit must comply with the national
regulations.
The table below indicates which value of various properties are acceptable
for certain materials of plate heat exchangers and which are not.
+The used materials have sufficient resistance.
0There is a risk of corrosion, water treatment is advisable.
-High risk of corrosion, water treatment is required.
Tab.1 Water quality requirements
Property Unit Heat exchanger Rating
Conductivity μ-Siemens / cm (at 20°C) < 700 +
pH-value pH < 6
6 - 7
7 - 9
> 9
-
0
+
-
Total hardness °dH < 15
> 15
+
0
Chloride ppm < 100 +
Sulphate ppm < 50
50 - 100
> 100
+
0
-
Carbon dioxide ppm < 5
5 - 10
> 10
+
0
-
Ratio [HCO3-] / [SO42-] > 1 +
Nitrate ppm < 100 +
Oxygen ppm < 1
1-8
> 8
+
0
-
1 Safety
7697291 - v.05 - 11032022 5
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Remeha E-HP AW 168 Cool Ace B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Remeha E-HP AW 168 Cool Ace B in the language / languages: English as an attachment in your email.

The manual is 12.52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info