417387
5
Zoom out
Zoom in
Previous page
1/12
Next page
5
To Connect to a Separate Preamp Output:
1. Do exactly as Step 1 above for connecting to a dedicated sub-woofer output.
2. Plug this phono connector into one of the separate preamp outputs
(assuming there is a left and a right output) and the XLR into the 600 Ohm
balanced Line level input of STUDIO. Note that this means STUDIO is
sensing only one channel, either right or left. Two separate sub-woofers will
be necessary for full stereo compatibility under these circumstances. This
can be advantageous in a very large room as it ensures better room coupling
from two spaced low frequency sources.
3. Connect to the mains as step 3 above.
To Connect to a 600 Ohm Balanced Line Output from a Mixing Desk:
1. Connect a three pin XLR to the open wire end of the STUDIO interconnect,
using the established pin connection convention. This means the RED wire
goes to Pin 1, YELLOW wire to Pin 2 and the BLACK wire to Pin 3. Note
that in this configuration (i.e. balanced) the signal is across the YELLOW
(phase) and the BLACK (anti-phase) with the RED to ground.
2. Plug the two XLR connectors into the mixing desk and into the balanced line
input to STUDIO.
3. Connect to the mains as step 3 above.
SETTING UP
Start by testing the effect of the controls with STUDIO sited in any convenient
position in your listening room.
Turn the two filter controls fully clockwise (maximum bandwidth) and the gain to
minimum. Play some music with known bass content, then adjust the gain control
for similar sound levels from your main system and your STUDIO. Now reduce
both filter controls to minimum. Notice that the level of the bass has almost
disappeared. This is because these very low frequencies are not being boosted by
your room. Without the ABC these very low frequencies would never be clearly
heard in your room. Increase the Gain control until this deep bass is heard.
Slowly, increase the coarse control one step at a time. If one position appears too
much, reduce to the lower setting then increase the Fine control a notch at a time
until there is a good match between the two systems. It may be necessary, also,
to readjust the Gain control. Do not worry if it is not immediately obvious which
setting is correct. It is sufficient at this stage that you perceive that there are
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rel studio at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rel studio in the language / languages: English as an attachment in your email.

The manual is 0,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info