413312
13
Zoom out
Zoom in
Previous page
1/20
Next page
REL Acoustics ST 5 User Manual
13
To connect to the amplifier/processor/receiver using the phono to phono
LFE interconnect
Alternative method for connecting at Low Level from pre amplifier
In some circumstances it is not possible to use the high level method of connection, for
example when using active speakers. Instead of using the attenuator as shown on page 15,
connect as shown below using a “Y” adapter from the left and right pre amplifier outputs and a
single phono to phono interconnect from the “Y” adapter to one of the low level inputs on the
REL.
Only use this method if the pre amplifier has two separate outputs.
In the unlikely event that the second pre amplifier output is only a parallel connection to the
other then this method will cause a mono signal to be sent to the main amplifier(s) or active
speakers.
Connect as shown above using a phono to phono interconnect. Plug one end into
the sub/LFE output on the amplifier/processor and the other end into the LFE LEVEL
input on the sub-bass system.
The output level can be adjusted by one of two methods.
1. By using the remote control: press the buttons marked LFE LEVEL ‘+’ or ‘-‘. The front
control panel will show ‘Hi’ on the two left hand digits. The volume level can be adjusted
up or down by pressing the ‘+’ or ‘-‘ buttons and the display will show 00 to 99 on the two
right hand digits.
2. By using the encoder control on the front control panel: press the control knob to select
‘LF’ on the two left hand digits, rotate control knob to select the value in the range 00 to
99 on the two right hand digits.
Phono to Phono Interconnect.
To sub/LFE output of
Amplifier/Processor
Sub LFE
Input
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rel strata 5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rel strata 5 in the language / languages: English as an attachment in your email.

The manual is 0,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info