601216
13
Zoom out
Zoom in
Previous page
1/27
Next page
REL Acoustics ‘ST III’ User Manual
13
To connect to MONO BLOCK power amplifiers using the high level
Neutrik UNBALANCED input
To engage the Neutrik Speakon plug, insert fully into socket and rotate clockwise until locked.
To remove the Neutrik Speakon plug, grip body of plug, place thumb on chrome lever, move
lever backwards rotate plug anti-clockwise (counter-clockwise in the US) quarter turn and
withdraw.
Supplied Neutrik Speakon High level Interconnect
RED
HI LEVEL input Release lever YELLOW + - + -
L R
MONO MONO
BLACK BLOCK BLOCK
SPK OUT SPK OUT
PRE AMPLIFIER
Ground
(see below)
High Level connections should be made to the same binding posts as the main
speakers
Connect as shown above. Connect RED to right monoblock speaker positive (red) terminal,
connect YELLOW to left monoblock speaker positive (red) terminal. The BLACK should be
connected to ground at the pre amplifier. If the pre amplifier does not have a dedicated
ground terminal, then use one of the chassis screws at the rear of the pre amplifier.
NOTE:- MAKE SURE THAT ANY CHASSIS SCREW WHICH IS USED IS NOT CAPTURED
ON THE INSIDE WITH A NUT, THE NUT COULD DROP INSIDE THE UNIT.
The output level is adjusted using the control marked HI LEVEL.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for REL Acoustics ST III at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of REL Acoustics ST III in the language / languages: English as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info