716161

Reer 46302 Manual

12
Zoom out
Zoom in
Previous page
1/56
Next page
- 10 -
Insert the 4 screw housings (a, c, d) together with the adjusting screws (e) and (f) into the 4
corners of the gate. Please follow the instructions of Ill. 2 - 5 exactly when inserting the parts
(a, c, d).
Push the screw housings (c) only slightly in, so that the colours remain visible, Ill. 4.
Push the screw housings (a) and (d) in completely, Ill. 2, Ill. 3, Ill. 5.
Attention! The screw housings (a, c, d) do not have an inside thread. The screws are merely
pushed in or pulled out.
Place the safety gate on the floor and make sure the gate stands upright in the middle of the
doorway so that there is no more than 62mm between the safety gate and the door frame. Ill. 6.
Pull the lower adjusting screws out evenly until they touch the mounting areas, Ill 7 and 8.
Mounting the wall shells (g)
When is the screw connection of the wall shells (g) absolutely necessary?
• On a wooden surface -> with the included wood screws (h)
• On plaster or soft surfaces -> with suitable screws and wall anchors 1)
Remove the protective foil on the adhesive surface on the back of the wall shells and place these
between the adjustment screws and the mounting surface, Ill. 09 and 10.
Tip: Make the mounting easier by only turning back the adjustment screw slightly on one side of
the door gate whilst the opposite adjustment screws of the gate provide support on the mounting
surface.
Using the key tighten the nuts on the lower part evenly until the screw housing (c) is pressed into the
frame so that only the green stripe is visible, Ill. 11.
ATTENTION! If in spite of installation of the wall shells the green colour in the colour indicator does
not appear, the surface to which it is attached is not stable enough. If this is the case, a protection
guard must be used for the screw connection, or the clamping surface of the wall must be
reinforced, e.g. by using the StairFlex protection board.
1) not included in scope of delivery
Step 1
Step 2
ATTENTION!
When is the screw
connection of the
wall shells
necessary?
adjusting the lower
adjustment screws
Note for installation in connection with extensions:
If you would like to install the door gate in connection with extensions, please start on page 11
and follow the instructions “Installation of Extensions”.
Installation
ATTENTION: The gate must always open in the direction away from the hazard zone!
In order to limit the opening direction, installation of the stopper (j) Ill. 1 is optional.
English (EN)
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Reer 46302 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Reer 46302 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish as an attachment in your email.

The manual is 4,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info