Manual Reer 36040 VapoDry (page 7 of 32) (English, German, Dutch, Danish, French, Italian, Polish, Spanish)

716268

Zoom out

Zoom in

1/32

1110

Safety instructions for installation

• When placing items inside the unit, ensure that the steam can reach all surfaces and condensate can run o.

• Never start the equipment without water and do not transport it during operation. Never add any liquid other than

drinking water to the container.

• Add 180 ml tap water to the equipment. You can use the practical measuring cup included to do so. If you add

less than 180 ml of water, the steriliser unit does not produce sucient amounts of steam to disinfect all items with

certainty.

• Caution! Always open and dismantle the bottles into individual parts to sterilise, otherwise the material may become

warped.

• Do not touch the equipment while in operation. The surfaces of the equipment become very hot during operation

and may cause burns.

CAUTION! Hot surface.

• Do not remove the cover during disinfection as the equipment contains boiling water. Beware steam escaping from

the vents in the cover. Never put a cloth or similar over the cover.

• Never open the equipment before the process is completed, as the items are then not disinfected.

• Pay attention when opening the disinfecting unit - hot steam escaping may cause burns.

• Bottles and other items are very hot directly after a hot steam disinfection and should only be removed using the

bottle gripper that is included.

• Use the disinfected parts immediately after removing them, as otherwise they will have to be disinfected again.

• Some condensate always remains in the equipment. Pour the water out of the unit and dry all parts of the equip-

ment. Caution - this remaining liquid may also be hot.

• The disinfecting unit requires about 15 minutes to cool down before it can be started again.

• Attention: Press the on/o button again to pause the disinfection and drying process. The disinfection

and drying process will begin again when you press the button again.

Cleaning

For reasons of hygiene and in order to keep lime deposits to a minimum, we recommend cleaning the steriliser,

removable basket and cover with a cloth after every use and removing remaining water from the steam container.

Always disconnect it from the mains and ensure that the equipment is cold before cleaning it. Do not immerse

the unit in water. The removable basket, cover, measuring cup and baby bottle mount unit are dishwasher-safe.

Do not use any scouring pads, scouring agents or solvents for cleaning; they might damage the equipment and

its surfaces.

Please ensure that the lter on the product base is not dusty. Remove the lter occasionally and clean it by simple

rinse with clear water.

Descaling

Environmental protection

The disinfecting unit must be descaled regularly, at least every month (more frequently in areas with very hard

water) in order to guarantee proper functioning of the equipment. A heating plate that appears dierent from

the outside with lime deposits or burnt-in milk residue does not constitute grounds for complaint. The warranty

does not cover any damage occurring due to this. The heating plate of your disinfecting unit may be cleaned with

traditional descaling products based on citric acid, e.g. using a reer fast bio-decalcier sachet or normal diluted

vinegar. Repeat the process in case of stubborn lime deposits. Please do not use chemical additives during

operation or cleaning.

Troubleshooting

Please retain your receipt, the user manual and part number. Warranty claims or claims from promises of guarantee

must be processed by the dealer.

The technical specication, instructions and characteristics of the product described herein have been compiled

to the best of our knowledge and belief and are correct at the time of printing. Any instructions provided by

reer should be correct and authoritative. Nevertheless,reer does not accept liability for potential errors in this

document and reserves the right to make changes to the product design and/or specications without prior notice.

Reproduction and disclosure of information contained in this copyright-protected document, in any form or by

any means - graphical, electronic or mechanical by photocopying, recording on tape or storage in a data retrieval

system (even in part), require prior written consent from reer.

At the end of its life, this product must not be disposed of as normal domestic waste, but should be recy-

cled at a collection point for electrical appliances. Please see the relevant syMaterials can be recycled as

specied. An important contribution to the protection of the environment can be made by reusing the unit,

recycling its components or otherwise reusing old applian-

ces. Please contact your local council to nd out more about

an appropriate disposal centre.

problem possible cause action

Why does the disinfection process

take so little time

You may have added insucient

water to the equipment

Add exactly 180 ml tap water to the

equipment

Device cannot be switched on No power supply

Insert the mains plug again and press

the on/o button on the equipment

Bottles and accessories are very hot

after the disinfection and drying

process

Disinfection and drying process

at over 90°C

Allow the bottles and accessories to

cool down and use the bottle gripper

included

Disinfection unit and bottles are

covered in white ecks after disin-

fection and drying

Equipment is calcied The disinfection unit must be descaled

Steam escaping from below the

cover

• Equipment was assembled

incorrectly

• Improper positioning of bottles

and other items

• Assemble equipment correctly

• Distribute bottles and other items

in such a way that the cover closes

completely

GBGB

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Reer 36040 VapoDry in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 14,6 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Reer 36040 VapoDry Manual

Product: