747995
20
Zoom out
Zoom in
Previous page
1/28
Next page
20
19. Binding Function
To enable transmitter and receiver to work together, they must be bound by the same digital code. In the delivery state,
transmitter and receiver are aligned with each other and can be used at once. The binding settings must be renewed
mainly after a replacement of the transmitter or receiver or to remove any interferences.
Before you can bind the receiver to the transmitter, check if the transmitter works in the right digital code (see previous
chapter).
To perform the binding procedure, proceed as follows:
Transmitter and receiver must be in direct proximity (distance
approx. 50 cm).
Switch off the transmitter.
Disconnect any servos that may be connected from the recei-
ver.
Connect the enclosed programming plug (1) to the „BAT“ con-
nection of the receiver.
The power supply of the receiver (receiver battery or speed
controller with BEC) is connected to any output of the recei-
ver.
Switch on the receiver. The receiver LED (2) starts to ash
quickly.
Press the binding button at the receiver (see also gure 1, item
10) and keep the button pressed.
Switch on the transmitter with the on/off switch with the binding
button pushed. The LED display in the transmitter starts to
icker.
When the LED in the receiver (2) ashes slowly after a few
seconds, binding, binding has been completed.
Release the binding button at the transmitter.
Switch off the receiver and transmitter and remove the pro-
gramming plug.
Re-connect the servos/controllers to the receiver.
Check the function of the system. If the system is not working properly, perform the process again or check the
digital code of the transmitter.
If you have switched the transmitter to the digital code „AFHDS“ and bind an „AFHDS“ receiver, the LED in
the receiver will not ash slowly but be lit permanently after binding.
Figure 15
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Reely HT-4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Reely HT-4 in the language / languages: English as an attachment in your email.

The manual is 3,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Reely HT-4

Reely HT-4 User Manual - German - 28 pages

Reely HT-4 User Manual - Dutch - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info