559628
15
Zoom out
Zoom in
Previous page
1/18
Next page
Reebok i-Trainer.S
26
Customer Support 0800 440 2459 Reebok i-Trainer.S
27
reebokfitness.info
Q My equipment is out of the warranty can you still help me?
A Yes we can still help, we have a large network of engineers that cover 98% of
the British Isles and can provide replacement parts. For a quote on parts or
engineer call out please contact our Technical Support phone line listed on
the back of this manual.
Q Can I keep my equipment in my garage?
A Yes, but not in a garden shed. Note if your equipment is kept in a garage,
ensure it is covered and placed on a mat or carpet. It is important to protect it
from being exposed to extremes in temperature, heat, humidity and moisture.
Q I have an error message on my screen what does this mean and what
canIdo?
A There are a number of error messages that may be displayed on your
computer. Please see the codes below:
E1 – No speed signal.
E2 – The computer can not interface with the computer chip.
E3 – When analysing the body fat this error will occur if the computer
can not read your pulse.
E5 or ERR-M – This indicates there is a fault with the servo motor.
If you have any of these errors we would advise for you to check all the
connecting wires in the back of the computer, the front post and the pulse
wires coming from the handle bars firstly. If this does not cure the problem
please contact us on Technical Support phone line listed on the back of
this manual.
Q The console does not display distance, speed or calories.
A Firstly the wiring that was connected during assembly needs to be checked.
These are located into the rear of the computer and halfway down the inside of
the handlebar tube. These can be disconnected completely then reconnected
to reset this function. If the console still does not function properly, please do
not hesitate to contact our Technical Support phone line above.
Troubleshooting
Q My new crosstrainer squeaks, is this normal?
A This is not normal there are some basic checks that we would advise you
to perform:
Please check all nuts and bolts are secure but not over tightened (it may be
worth loosening slightly if noise seems to be coming from a specific area).
Please check that all washers are fitted and in the correct position.
Please lubricate all moving parts with either WD40 or light grease
(grease is the best option).
Ensure front and rear stabilisers are attached correctly.
Ensure the front upright post is locked in position with no movement.
Make sure all bolts are tight.
Please check pedal/foot plates are fully secure.
If these checks do not help to remedy the fault please don’t hesitate
to contact us.
Q When I press the buttons on my cross trainer it does beep but there is no
display on the screen. Do I need a new computer?
A This may be a simple contrast setting please follow the instructions below:
Remove the power from the machine.
Insert the power back to the machine.
Press and hold the “stop” button.
While holding the “stop” button tap the “up” arrow.
You will find the screen start to reappear.
When you are happy with the screen release all the buttons.
If this does not work please contact our Technical Support phone line listed
on the back of this manual.
RFE 4489_RE014200_iTrainerS_UMFINAL.indd 26-27 25/06/2010 15:32
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Reebok i-Trainer S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Reebok i-Trainer S in the language / languages: English as an attachment in your email.

The manual is 4,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info