Manual Redmond RHB-2919-E (page 7 of 168) (All languages)

659471

Zoom out

Zoom in

1/168

RHB-2919-E, RHB-2923-E

GBR

Start processing at a low speed to avoid splatter. Do not use the blender to

process coffee beans, ice cubes, sugar, grain, beans, and other tough meals.

Do not use the chopper bowl for blending or whisking. The central pin at the

bottom of the chopper bowl can damage the attachment. Use the beaker

provided with the appliance.

To Operate the Blender

1. Fill the beaker or a similar vessel with food.

2. Connect the blending attachment to the motor unit and turn counter-

clockwise until it clicks into place.

3. Plug in the appliance. Select the required speed setting.

4. Hold the vessel steady and place the blending attachment in the food.

Press and hold down the Power button. When processing raw vegetables,

fruits, and other hard meals turn the speed control knob to increase the

speed or press and hold down the Turbo mode button.

5. Blend foods using circular up-and-down motion.

6. After use unplug the appliance. Turn the blending attachment clockwise

to disconnect from the motor unit. Clean the appliance following the

procedure outlined in A2 section.

To Operate the Whisk

1. Fill the beaker or a similar vessel with food.

2. Insert the whisk attachment to the gear box until it clicks into place.

3. Connect the gear box to the motor unit and turn counterclockwise until

it clicks into place.

4. Plug in the appliance. Turn the speed control knob clockwise to setting

1 (minimum speed).

5. Hold the vessel steady and place the whisk attachment in the food. Press

and hold down the Power button. Turn the speed control knob counter-

clockwise to increase the speed if necessary (from 1 to 5). To whisk at a

maximum speed press and hold down the Turbo mode button.

6. Whisk the meal using clockwise circular motion.

7. After use unplug the appliance. Disconnect the attachment and the gear

box from the motor unit by turning clockwise. Clean the appliance fol-

lowing the procedure outlined in A2 section.

To Operate the Chopper (RHB-2919-E)

1. Place the chopper bowl on a at and stable surface.

2. Fit the blade on the central pin at the bottom of the chopper bowl. Note:

the blade is very sharp, handle with caution! Always hold the blade by

the plastic collar.

3. Fill the bowl with food. Do not ll above the maximum ll mark. Follow

the procedures outlined in “General Guidelines” section.

Fit the lid onto the bowl, aligning the crosspiece of the plastic collar with

the corresponding notches in the center of the lid. Gently press the lid

down and rotate clockwise until it clicks into place.

5. Connect the motor unit with the chopper gear box.

Plug in the appliance. Select the speed setting: harder meals require

higher chopping speed. Turn the speed control knob clockwise to increase

the speed.

7. Steadily holding the vessel with one hand press and hold down the Power

or Turbo mode button. Use Turbo mode for meat and other tough meals.

8. After use unplug the appliance. Disconnect the motor unit. Turn the lid coun-

terclockwise to remove. Remove the blade holding it by the plastic collar.

9. Clean the appliance following the procedure outlined in A2 section.

III. BEFORE CONTACTING SERVICE CENTER

Problem Possible cause Solution

Appliance does

not work

Power cord is not con-

nected to an electrical

outlet

Connect the power cord to an electrical

outlet

Electrical outlet is not

working properly

Connect to properly working electrical

outlet

Strong vibration

during operation

Food pieces are too large Cut food into smaller pieces

Plastic smell

during use

Appliance is overheated

Reduce continuous operation time. In-

crease time intervals between uses.

Appliance is new, the

smell is coming from

protective cover

Thoroughly clean the appliance (refer to

section A2). The smell will disappear

after few uses.

IV. PRODUCT WARRANTY

We warrant this product to be free from defects for a period of 2 years from the

date of purchase. If the appliance fails to operate properly within the warranty

period and is found to be defective in material or workmanship, we will repair

or replace it free of charge. This warranty comes into force only in case an

original warranty service coupon with a serial article number and an accurate

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Redmond RHB-2919-E in the language / languages: All languages as an attachment in your email.

The manual is 2,6 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Redmond RHB-2919-E Manual

Product: