814904
10
Zoom out
Zoom in
Previous page
1/20
Next page
10 | P a g e
How to operate the heater
NOTE: The heater may emit a slight harmless smoke when first used. This smoke is a normal condition
caused by initial heating of the infrared element. It will occur only briefly and is not harmful.
Un-package heater: cut open tape area, fold back flaps and gently turn entire box upside down. Lift
box from Styrofoam packing. Remove Styrofoam, turn upright. We recommend keeping the
package for off-season storage and any transporting needs.
Position: Find a level and unobstructed location to place the unpackaged heater.
Plug in: Plug the power cord directly into an unused grounded 120 volt 15 amp or higher circuit
receptacle.
Set ON/OFF switch to ON: Press down the switch located on the rear of the heater to the ON
position (I). This provides electricity to the unit.
Set POWER to ON: Press the POWER button on the LCD panel (or remote control) to turn on the
unit. The Actual Temperature will be displayed. NOTE: The heating function will still not be active.
You must press the HEATER on/off button (see below) to activate the heating function.
Heater ON/OFF: Press the HEATER power button to turn on or off the heating function of the heater.
The fan will not operate until the heating element has reached a temperature high enough to begin
the warming process. During the period that the fan will not run, and the message HEATING UP
will show on the LCD display to indicate that the heater is heating up.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Redcore CONCEPT R-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Redcore CONCEPT R-2 in the language / languages: English as an attachment in your email.

The manual is 1.15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info