597825

Red Scarlet X 3.2 - 2012 Manual

167
Zoom out
Zoom in
Previous page
1/242
Next page
955-0003_v3.2, Rev- A1 COPYRIGHT © 2012 RED Digital Cinema
165
HEADPHONE
A 3.5mm stereo jack provides two channels of adjustable level analog audio for monitor headphones.
Headphone Output Connector
PIN SIGNAL DESCRIPTION DIRECTION
A (TIP) LEFT Left channel audio Out
B (RING) RIGHT Right channel audio Out
C (SLEEVE) GND Camera ground --
The camera’s four audio channels may be monitored in pairs: either 1L - 2R or 3L - 4 R or as a quad mix
of 1+3L – 2+4R based on the MIX parameter. Default is 1L-2R.
Output volume may be adjusted as follows.
Volume: (master volume) Adjusts headphone volume equally for left and right outputs.
Range is -18dB to 0dB in 1dB steps. Default is -9dB.
NOTE: for maximum output signal quality, only use high impedance headphones.
NOTE: in Version 3.x software the above selection is not available, the output is set to 1L / 2R.
SYNC (VIDEO SYNC)
A 4-pin LEMO connector supports shutter synchronization, GPI, timecode and genlock input signals.
The shutter Sync input signal acts as an immediate response hardware trigger to commence a scan.
This is useful for motion control and other applications where the camera is driven by a master timing
device. When using SYNC as the camera shutter timing reference, fine shutter start time timing
(SHUTTER PHASE) is disabled; make any desired timing adjustments at the external SYNC generator.
Alternatively, this input may be used as a GPI (General Purpose Input) trigger, whose function is
programmed in the USER KEYS menu. Default function for the GPI trigger is Record Start / Stop.
The SMPTE timecode input provides a frame accurate time stamp for each frame of recorded video.
External TC must be chosen in the Project > Timecode menu. When SMPTE timecode is detected it will
align the internal TC value to the external TC signal at every :00 frame crossing of the external TC signal.
A
B
C
… 167 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Red Scarlet X 3.2 - 2012 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Red Scarlet X 3.2 - 2012 in the language / languages: English as an attachment in your email.

The manual is 10,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info