A Power On/Off switch B Aux Power / GPIO A
C Aux Power / GPIO B D Camera 11.5 - 17V D.C Input
E e-SATA Interface (to RED-DRIVE or RED-RAM magazine)
Underneath the status display key group are the Power On/Off switch (top left) two 4 pin Aux-
iliary Power /GPIO outputs, 6 pin camera system POWER input and a 16 pin DRIVE interface.
Each Auxiliary Power / GPIO connector can supply 1.75 amps of unregulated 11.5 – 17V DC
power to accessories such as range finders or compact lens motors. In addition, the upper con-
nector provides a GPI trigger for Record Start / Stop and an In-Record tally output. The lower
connector provides a GPI trigger for Single Frame Record and a Frame Recorded tally output.
The DRIVE interface utilizes standard e-SATA protocols, and supplies power and data to record
REDCODE RAW compressed video data plus audio to RED-DRIVE or RED-RAM digital media.
To power the camera up from a RED BRICK battery, press the power on/off switch once.
To power the camera up from a RED-CHARGER, connect it via the supplied power cable. Plug
the RED-CHARGER into an AC power source and switch it on. After the green LED illuminates
on the RED-CHARGER, the camera can be powered on by pressing its On/Off switch.
To power the camera down, press the power on/off switch once.
Note: After power down, is recommended that you wait 5 seconds after the
camera’s green status LED goes off before powering the camera up again.