23317
30
Zoom out
Zoom in
Previous page
1/43
Next page
Chapter 4: Calibration
21
Chapter 4: Calibration
4.1 Introduction
The procedures in this Chapter must be carried out before the
equipment is used operationally, to optimise the performance of the
instrument with the vessel.
Calibration information is presented in flow chart form. The flow charts
show the various calibration screens and key presses necessary to carry
out calibration. All key presses are momentary unless otherwise stated.
EMC conformance
Always check the installation before going to sea to make sure that it is
not affected by radio transmissions, engine starting etc.
4.2 User calibration
User calibration enables you to:
Set the required units for speed readings. Either KTS (knots), MPH
(miles per hour) or KPH (kilometres per hour).
Set the required distance units. Either NM (nautical miles), SM
(statute miles) or KM (kilometres).
Select water temperature units. Either °C or °F, as required.
Set the speed display response. Use higher response values when
boating in conditions requiring rapid updates of the current speed
(e.g. competition sailing or on power boats). Use slower response
values when you require an average speed over a longer period of
time (e.g. when cruising, especially in heavy seas).
Set the correct speed reading, either by using a Cal factor screen to
adjust the calibration factor, or by applying Speed Over Ground
(SOG) as the current speed. Your vessel must be moving at 0.5 KTS
or more and be receiving SeaTalk SOG data, to enable SOG to be
applied as the current speed. This should be done only in conditions
of zero tide and current.
To carry out User calibration, power up the instrument then follow the
procedure in the User calibration flow diagram.
157_2c04.p65 01/05/01, 12:2321
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Raymarine ST40_SPEED at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Raymarine ST40_SPEED in the language / languages: English as an attachment in your email.

The manual is 0,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info