23299
16
Zoom out
Zoom in
Previous page
1/39
Next page
Chapter 2: Installation
13
2.3 Mounting the Display Head
D682a
2
4
1
35
6
1 Display head 2 Sealing gasket 3 Fixing studs 4 SeaTalk or power cable
5 Fluxgate compass cable 6 Thumb nuts
1. Make sure the bulkhead to which the display head (1) is to be mounted
is smooth, flat, and clean.
2. Use the fitting template (supplied) to mark the centres for the two
fixing studs and the display head cable boss.
Please note...
To allow for the fitting of protective covers, adjacent instruments
must have a 6mm (1/4in) gap between them (116mm centre to
centre min.).
3. Drill two 5mm (0.2in) diameter holes for the fixing studs (2).
4. Using a 60mm (2.375in) diameter cutter, drill a location hole for the
instrument connector boss.
5. Plug the moulded end of the power cable in to one of the SeaTalk
terminals.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Raymarine ST30_COMPASS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Raymarine ST30_COMPASS in the language / languages: English as an attachment in your email.

The manual is 0,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info