23299

Raymarine ST30_COMPASS Manual

11
Zoom out
Zoom in
Previous page
1/39
Next page
ST30 Compass Installation and Operation Handbook
8
Important Information
All Autohelm equipment and accessories are designed to the highest standard
for use in the leisure marine environment.
Their design and manufacture conforms to the latest Electromagnetic
Compatibility (EMC) standards, but good installation is required to ensure that
performance is not compromised. Although every effort has been taken to
ensure that they will perform under all conditions, it is important to understand
what factors could affect the operation of the product. To avoid the risk of
EMC problems, all Autohelm equipment and cables connected to it should be;
❏ At least 1m (3 feet) from any equipment transmitting or cables carrying
radio signals e.g. VHF radios, cables and antennas. In the case of SSB
radios, the distance should be increased to 2m (7ft).
❏ At least 20m (66 feet) from large vessels equipped with radar.
❏ More than 2m (7 feet) from the direct path of a radar beam.
The following points should also be noted;
❏ Genuine Autohelm cables should be used at all times. Cutting and rejoining
these cables can compromise EMC performance and so should be
avoided unless doing so is detailed in the installation manual.
❏ Autohelm equipment should be serviced only by authorised Autohelm
service engineers. They will ensure that service procedures and replace-
ment parts used will not affect EMC performance. There are no user
serviceable parts in any Autohelm product.
❏ Voltage drops below 10v in the power supply to our products can cause
the equipment to reset. This will not damage the equipment but will cause
the loss of some information and can change the operating mode. This
most frequently happens during engine starting, and so to reduce the risk
of this occurring, it is recommended that the equipment is supplied from a
different battery than the one used for engine start.
❏ Some products generate high voltages, and so never handle the cables/
connectors when power is being supplied to the equipment.
❏ Always check the installation before going to sea to make sure that it is not
affected by radio transmissions, engine starting etc.
❏ In some installations, it may not be possible to prevent the equipment from
being affected by external influences. In general this will not damage the
equipment but can lead to it resetting, or momentarily result in faulty
operation.
Please keep these notes for future reference.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Raymarine ST30_COMPASS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Raymarine ST30_COMPASS in the language / languages: English as an attachment in your email.

The manual is 0,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info