558415
27
Zoom out
Zoom in
Previous page
1/118
Next page
9. Push the transducer and pivot arm down until the
bracket clicks into place.
10.Loosen the transducer pivot bolt approximately 3
turns to enable adjustment.
1
D12 64 3-1
1 Pivot bolt location
11. Adjust the angle of the transducer using the
ratchet mechanism, one click at a time until the
transducer face is parallel with the waterline.
The transducer position will be adjusted further
during testing (see Testing the transducer).
D12 63 9-1
12.Tighten the transducer pivot bolt.
13.Tighten the kick-up adjustment screw to achieve
the desired kick-up force.
The kick-up force needs to be adequate to
prevent the transducer from kicking-up during
testing but also needs to be loose enough so that
it can kick-up should the transducer be struck by
an object when underway.
Note: The third locking screw is not used until the
transducer has been successfully tested.
4.2 Cradle mounting
Follow the steps below to mount the display’s cradle.
Before mounting ensure that you have:
selected a suitable location.
installed the transducer and routed the
power/transducer cable to the selected display
location.
00
00
D12630-2
0
0
0
0
1. Mark the location of the cradle base’s screw
holes on the chosen mounting surface.
2. Drill holes for the screws using a suitable drill,
ensuring there is nothing behind the surface that
may be damaged.
3. Use the 3 screws supplied to attach the cradle
base securely to the mounting surface.
4. Attach the display cradle to the base.
5. Tighten the centre screw to secure the display
cradle to the base.
Note: The appropriate torque to use when drilling
depends on the thickness of the mounting surface
and the type of material.
Mounting
27
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Raymarine Dragonfly at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Raymarine Dragonfly in the language / languages: English as an attachment in your email.

The manual is 11,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Raymarine Dragonfly

Raymarine Dragonfly User Manual - German - 96 pages

Raymarine Dragonfly User Manual - Dutch - 96 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info