558422
14
Zoom out
Zoom in
Previous page
1/460
Next page
RF exposure
This equipment complies with FCC / IC RF exposure
limits for general population / uncontrolled exposure.
The wireless LAN / Bluetooth antenna is mounted
behind the front facia of the display. This equipment
should be installed and operated with a minimum
distance of 1 cm (0.39 in) between the device and
the body. This transmitter must not be co-located
or operating in conjunction with any other antenna
or transmitter, except in accordance with FCC
multi-transmitter product procedures.
FCC
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference
received, including interference that may cause
undesired operation.
FCC Interference Statement (Part
15.105 (b))
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment
and receiver.
3. Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
4. Consult the dealer or an experienced radio / TV
technician for help.
Industry Canada
This device complies with Industry Canada
License-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause interference; and
2. This device must accept any interference,
including interference that may cause undesired
operation of the device.
This Class B digital apparatus complies with
Canadian ICES-003.
Industry Canada (Français)
Cet appareil est conforme aux normes d'exemption
de licence RSS d'Industry Canada.
Son fonctionnement est soumis aux deux conditions
suivantes:
1. cet appareil ne doit pas causer d'interférence, et
2. cet appareil doit accepter toute interférence,
notamment les interférences qui peuvent affecter
son fonctionnement.
Cet appareil numérique de la classe B est conforme
à la norme NMB-003 du Canada.
Japanese approvals
In the frequency band used for this device, campus radio
stations (radios stations that require a license) and specied
low power radio stations (radio stations that do not require
license) for mobile identication and amateur radio stations
(radio stations that require license) used in industries such as
microwave ovens, scientic, medical equipment devices and
production line of other factories are also being operated.
1. Before using this device, please make sure that campus
radio stations and specied low power radio stations for
mobile identication and amateur radio stations are not
being operated nearby.
2. In case there is any case of harmful interference to
campus radio stations for mobile identication caused by
this device, please immediately change the frequency
used or stop the transmission of radio waves and then
consult about the measures to avoid interference (for
example, the installation of partitions) through the contact
information below.
3. Besides, when in trouble, such as when there is any
case of harmful interference to specied low power
radio stations for mobile identication or amateur radio
stations caused by this device, please consult through
the following contact information.
Contact information: Please contact your local authorized
Raymarine dealer.
Third party software license
agreements
This product is subject to certain third party software
license agreements as listed below:
GNU LGPL/GPL
JPEG libraries
OpenSSL
FreeType
14
a Series / c Series / e Series
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Raymarine a Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Raymarine a Series in the language / languages: English as an attachment in your email.

The manual is 30,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Raymarine a Series

Raymarine a Series User Manual - German - 396 pages

Raymarine a Series User Manual - Dutch - 394 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info