Manual Rayline R90 (page 13 of 36) (English, German, Dutch, French, Italian, Polish, Spanish)

752315

Zoom out

Zoom in

1/36

Bedienungsanleitung

R/C Rayline R9 2.4 GHz Quadrocopter

Automatic Return by a button: Long Press the remote control camera button for 2 Seconds. Remote

control aircraft noise occuring drops, the tail light flashes, the aircraft began to return. Note! In the use

fo return it must be in the code when the aircraft head is placed just before. And when in flight, super

control cannot change the direction. CF-Mode: On the front of the saucer, long after take-off by remote

control codes headless mode button for 2 seconds to enter the sound drops headless mode while the

remote controller. Then press 2 seconds to exit the headless mode. Must be put on the front yard of

the aircraft are using a headless mode (red pulp toward the front). Attention! When people cannot

change the direction of control! X-Axis / Y-Axis: Often by the remote boot on the X-Axis calibration

button for 3 seconds to enter the code after a good X-axis calibration, this time the body of the Ufo

LED flashes until all levels of uniform rotation Ufo LED light, X-axis calibration is complete. To take up

flying saucer vertical Y-Axis calibration press button 3 seconds to enter the Y-Axis calibration. LED

flashing Ufo flying saucer straight vertical uniform rotation ended LED lit. X-Axis calibration, , the

calibration needs reboot ta take effect. Ufo has been calibrated at the factory. If deviations follow the

instructions above calibration.

Features: This product uses 5.8G transmission system. The transmission system is about 500 Meter

high anti-jamming efficiency, easy installation. Using 720P HD Camera, 10,92 cm /4.3 inch large-

screen display.

The spacecraft on a flat position, the Lipo-Battery

icon in accordiance with direction pushing people

electric socket to position. Body LED flashing

lights at this time not to move the body, makes

the remote controller reads the neutral point of

frequency and gyroscope

Open the power supply control switch, remote

control issued a bit of noise, a few seconds after

the end of the fuselage LED noise, at the same

time often bright, completes to the code

Remove the flight vehicle battery safely at the

conclusion of flight. This should be made into a

post flight habit to acoid unforeseeable problems.

Warning: If left connected in the flight vehicle for

long duration, the battery may be damaged due

to over-discharge, or even become fire hazards

Turn off the transmitter. If transmitter is not to be

used for a long duration, please remove the

battery for storage. Warning: If the AA batteries

are left in the transmitter, potential leakage could

occur which may damage the transmitter, and

create fire hazards

2. 2.4 GHz Remote

3. FPV

3A - Camera

3B - Antenne

3C - Antenna

3D - Display

3E - Cover

4. Binding of radio transmitter and receiver

2A Power LED 2I LCD-Display 2R Power-LED

2B Camera 2J Refer Headless Mode operation 2S Stick Mode Indicator

2C Speed Control 2K Foto (Headless Mode press 2 sec.) 2T Speed Trim tips

2D Speed 2L 100% 2U Diversion Trim tips

Trim 2M "Crab" Trimm 2V Overview

2E Direction Trim 2N Backwards/Forwards Trimm 2W "Crab" Trim-Tips

2F X-Axis Calibration 2O Direction Control 2X Stick Mode Indicator

2G Y-Axis Calibration 2P Roll 2Y Battery Level Transmitter

2H 80% 2Q Antenna

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Rayline R90 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 1,65 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Rayline R90 Manual

Product: