Manual Ravelli AURORA (page 24 of 76) (English, German, Danish, French, Italian, Spanish)

597712

Zoom out

Zoom in

1/76

Pag.24

Important: the use of aggressive detergents or diluents can damage the

surfaces of the stove.

9.2. Cleaning the fire pot before and after each lighting

You must check that the fire pot, where the combustion takes place, is

clean and that no waste or residue blocks the holes, in order to always

guarantee excellent combustion of the stove, thus avoiding possible

overheating, which could causes changes in the colour of the paint or

flaking of the door. as well as failing to light the stove.

Clean basket with all the

holes clearly visible

Basket needing cleaning

with the holes blocked by ashes

Only a clean fire pot can guarantee that the pellet stove functions without

problems. During functioning. deposits may be formed, which have to be

immediately eliminated.

It is easy to see when the fire pot has to be cleaned! It only needs a

glimpse, each day, before switching on. For minor cleansing, it can be left

in the stove, but if the residue is difficult to remove, it has to be extracted

from its housing and the waste scraped out.

The residue of ash depends on the quality of pellets used.

Important: even with a new batch of pellets, although using the same

brand, there may be differences during combustion and therefore they

may dirty to a greater or lesser extent.

Correct cleaning, done on a daily basis, allows the stove to burn optimally

and to have a good yield, avoiding malfunctioning which in the long term

could require technical assistance to reset the stove.

9.3. Cleaning the FIREX 600

All Ravelli products have a combustion chamber made with FIREX 600,

a material based on vermiculite, the result of research and development

by Ravelli. The main features of FIREX 600 are resistant to heat, its

lightness and excellent insulating capacities, improving the combustion

and performance of the stove.

During combustion, FIREX 600 turns white, due to an effect called

PYROLYSIS, making the flame clear and shining. If the combustion is

regulated in an optimal way, the FIREX 600 interior always remains clean

and white.

The condition of FIREX 600 is therefore a thermometer to understand

whether the combustion is good or not.

FIREX 600 LIGHT – EXCELLENT COMBUSTION

FIREX 600 DARK – POOR COMBUSTION

Firex 600 does not require special maintenance, it only has to be dusted

with a brush to remove the ash that is deposited during combustion.

Abrasive sponges to clean to most resistant waste should not be used

as they could compromise the thickness of the FIREX600 panel, creating

critical points of breakage.

The tube of the vacuum cleaner should not be used in direct contact with

FIREX 600.

Wet cloths should not be used to clean FIREX 600.

FIREX 600 is resistant to heat but not to knocks; handle with care if moved.

FIREX 600 may show a slight abrasion after a few hours of functioning,

this is perfectly normal as the flame creates microgrooves in the panel

without compromising it.

The duration of FIREX 600 depends only on how maintenance is carried

out.

The pellet stove is a generator of heat with a solid fuel and as such

requires servicing by qualified personnel at least once a year at the start

of the season. This maintenance has the purpose of ascertaining and

ensuring the perfect efficiency of all the components.

We recommend you draw up an annual contract for maintenance of the

product with your installer/dealer.

10. GUARANTEE

10.1. Certificate of Guarantee

Ravelli thanks you for the confidence you have placed in it with the

purchase of one of our pellet stoves and invites the purchaser to:

•

examine the instructions for the installation, use and maintenance of

the stove.

•

examine the conditions of guarantee shown below.

•

The enclosed coupon must be filled in and stamped by the installer. If

this does not occur, the product will not be covered by the guarantee.

10.2. Conditions of guarantee

The limited guarantee covers defects of manufacturing materials, on

condition that the product has not been broken due to an incorrect use,

carelessness, wrong connections or errors of installation.

The following are not covered by guarantee:

•

vermiculite (Firex 600);

•

the glass of the door;

•

the fibre gaskets;

•

the painting;

•

the stainless steel combustion basket;

•

the resistance;

•

the cast majolica

•

any damage caused by inappropriate installation and/or handling of the

stove and/or shortcomings by the consumer.

The use of poor quality pellets or of any other material could damage

components of the stove causing the termination of their guarantee and

the annexed responsibility of the manufacturer.

The pellets which meet the requisites listed in the chapter on them should

be used.

All damage caused by transport are not acknowledged, therefore please

carefully check the goods on receipt, immediately advising the dealer of

any damage.

All the manufacturer’s guarantees are shown here and no complaint may

be made to the manufacturer according to any other guarantee, report or

request.

The guarantee coupon must be detached and sent to the following ad-

dress within eight days of purchase:

Ravelli srl - Via Kupfer 31 - 25036 Palazzolo s/O Brescia ITALY

10.3. Information and problems

For any information or problems, please contact your dealer or service

centre, the only people who can meet any request you may have problem,

if necessary, who can intervene directly.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ravelli AURORA in the language / languages: English, German, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 3,8 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ravelli AURORA Manual

Product: