802106
24
Zoom out
Zoom in
Previous page
1/52
Next page
www.ratio.nl
24
www.ratio.nl
8. Connection Current Transformers and Sensorbox
In order to measure the current, Current Transformers are used (type
SCT013-00, one for each phase). Clip them around the L1, L2 and L3
wires and plug the other end into the Sensorbox.
The Current Transformers should be placed where the Mains connection
enters the building. This way it will be possible to measure the total
current per phase and send this information through the Sensorbox to the
Smart Box (see picture page 25)
The data cable on the Sensorbox should be connected to terminals A
(white), B (yellow), +12V (brown) and GND (green).
Current Transformer Sensorbox
NOTE: The date cable between Sensorbox and Smart Box is not
supplied. You can use a standard UTP cable or 4 x 0,25 mm2
data cable.
Connect the data cable in the charging station with the supplied 4 pole
connector. Master/Slave configuration: Connect the A, B and GND
connection from the Master to the Slave(s). So A connects to A, B goes to B
etc. Make sure that the +12V wire coming from the Sensorbox is connected
to the Master Smart Box only.
9. Close bottom cover and carefully slide metallized cover over the Charge
Station.
IMPORTANT: OUTLET VERSION before closing outlet cover, be sure
the outlet is unlocked!
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ratio SmartBox at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ratio SmartBox in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 1.74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info