632982
19
Zoom out
Zoom in
Previous page
1/32
Next page
Battery Charging
The charging socket is located on the upper left-hand side of the tiller. Rotate
the protective cover and push in the plug. When the vehicle is charged remove
the plug, and reposition the protective cover to keep the water out (Fig 20).
The battery charger has coloured charge status indicating LEDs / lamps (Fig 21).
When the charger is connected and switched on the first lamp will illuminate
red. If no mains power is present, no lamps will be lit. When the battery is
being charged the second lamp will illuminate orange and when this lamp
changes to green, the batteries are fully charged. Always ensure that the lamp
shows green before switching off and disconnecting the charger at the mains.
Connection Instructions
When you receive your vehicle the batteries are only partially charged
always fully charge them before use, preferably over-night.
1. Place your machine in an area that is dry and well ventilated.
Make sure a power point is nearby.
2. Check the vehicle is switched off and the key removed.
19
Warning! When charging batteries NEVER smoke or charge batteries in a place where there are naked
flames such as gas-fired heaters as, under exceptional circumstances, batteries may give off gases that
could ignite and explode. If the scooter has been damaged, it is possible that the batteries have been
a
ffected. In this case do not charge the scooter and refer to your dealer for assistance. Never charge the
scooter outside as the charger is not designed to get wet. If the charger appears damaged in
any way do not use it and contact your dealer for a replacement.
Warning! Always charge in a dry, well ventilated area.
Warning! It is strongly recommended that the mains socket used for charging the scooter is protected
by a 30 m/A RCD (residual current device). Many buildings have sockets protected by a system based
RCD. If you are in doubt as to the level of protection in your charging location then either purchase a plug in
RCD or consult a qualified electrician to verify that your charging location mains sockets are protected.
Warning! If batteries are damaged or frozen they could heat up during charging and in an extreme case,
explode.
Warning! Do not attempt to open the battery box/enclosure, there are no user serviceable parts inside. It
may be necessary for some carriers such as airlines to physically disconnect the batteries for transit. If this
is the case the battery cover can be removed without the use of tools once the seat has been removed.
This should only be done by appropriately skilled/qualified personnel.
Warning! Never use a different battery charger to that supplied by your dealer. Damage or injury may
occur if you do!
Warning! When charging batteries NEVER connect or disconnect the charger from the scooter while it is
still connected to the mains. - Remove the charger mains plug from the wall socket having first switched
the mains socket off if a switch is provided.
20
21
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rascal Vision at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rascal Vision in the language / languages: English as an attachment in your email.

The manual is 1,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info