661013

Ransomes Hydraulic 5-7 mk4 Manual

40
Zoom out
Zoom in
Previous page
1/102
Next page
en-40
9 ADJUSTMENTS
9.4 BACKLAPPING ____________________________________________________
Routine cylinder backlapping is part of a general
maintenance plan for cylinder mowers.
NOTE:Even when the engine is OFF, rotating one cylinder
may cause the others to rotate.
Use the following procedure with the engine off and the
cylinders disengaged.
1. Wash the cylinders and bottom blades.
2. Slightly back off the cylinder to bottom blade
adjustment.
3. Apply lapping compound to the cylinders BEFORE
starting the engine and engaging the cylinders.
NOTE:DO NOT apply lapping compound to cylinders
UNLESS the engine is off and the cylinders disengaged.
DO NOT apply lapping compound to rotating cylinders.
4. Lower the cutting units so they are firmly on the ground, apply the parking brake, place the cylinder control
switch (A) in the backlap position. With the operator in the operating position, start the engine. DO NOT
run the engine in an enclosed area.
5. Run the engine at idle speed. Start the PTO. Engage the reel drive (B) from the operators position on the
machine. The engine revs may need to be increased to allow the units to engage but then should be
returned to idle to limit cylinder speed.
6. Backlap reels for several minutes, periodically disengage cylinder drive, shut off engine and check the
blade condition. Add additional backlapping compound and adjust cylinder to bottom blade clearance.
Return to the operating position and continue backlapping until all blades are uniformly sharp.
7. Disengage cylinder drive, shut off engine and thoroughly wash all backlapping compound from cylinders
and bottom blades. Apply a thin coating of oil to all sharpened surfaces.
8. For a finer cut, file across the front face of the bottom blade to remove any burrs from the sharp edge.
9. Adjust the cylinder to bottom blade (see cutting unit manual).
A
B
… 40 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ransomes Hydraulic 5-7 mk4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ransomes Hydraulic 5-7 mk4 in the language / languages: English, Dutch as an attachment in your email.

The manual is 21,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info