661013

Ransomes Hydraulic 5-7 mk4 Manual

29
Zoom out
Zoom in
Previous page
1/102
Next page
en-29
7 OPERATION
7.3.15 CUTTING UNIT REMOVAL ___________________________________________
Before cutting unit removal a lift arm restraint tool should
be used.
1. To restrain lift arms 1,4 & 5 use the shorter lift arm
restraint tool.(B) For lift arm 1 the lift arm restraint
tool should be fitted between number 1 lift arm and
number 4 transport lock lever.
To restrain lift arms 6 & 7 use the longer lift arm
restraint tool.(C)
To restrain lift arms 2 & 3 use lift arm restraint
tool.(D)
2. Park the machine on a level flat surface. Lower the
cutting unit to be removed. Fit the relevant lift arm
restraint tool between the lift arm transport latch pin
and the transport lock lever. Fit the R-clip.(A) Adjust
the turn-buckle so the lift arm is held firmly in
position. Cutting unit can now be removed. Care
should still be taken not to stand over the lift arm.
3. Once the cutting unit has been removed, if the lift
arm restraint tool is to be removed before refitting of
the cutting unit an assistant will be required. The lift
arm will have approximately 30kg of upward force at
the lift arm end. The lift arm should be held down so
the restraint tool can be removed, keeping body
clear from above the lift arm, then slowly let the lift
arm raise into the transport position.
4. Refitting is a reversal of removal.
WARNING
Stored Energy In Lift Arms Can Cause
Serious Injury. Only Experienced
Personnel Should Attempt Cutting Unit
Removal Or Spring Adjustment.
… 29 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ransomes Hydraulic 5-7 mk4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ransomes Hydraulic 5-7 mk4 in the language / languages: English, Dutch as an attachment in your email.

The manual is 21,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info