Introduction
Congratulations on the acquisition of your new gas replace and on becoming a RAIS or ATTIKA
customer!
In this section you can learn how to set up, among other things, the remote control for your gas
replace. It is important that you read the manual thoroughly so that you get the most out of your new
gas replace.
Start-up
In this section you can learn how to set up the remote control for the gas replace.
Inserting batteries in the remote control
Insert two 2 x AAA 1.5 V batteries in the remote control.
When using the replace for the rst time in the year, you should replace the batteries. Replace all of
the batteries at the same time. Use only good quality alkaline batteries.
Never use pointed tools to remove the batteries from the box.
Inserting batteries in the receiver
The receiver can be connected to a power supply or can use batteries. If there is a power failure, four
AA batteries can be tted in the receiver. NB: If batteries are used in the receiver, the LED light and
MyFire wi--box will not operate.
Synchronisation of the remote control and receiver
You must rst synchronise the remote control and
replace receiver in order for the remote control
to function. Procedure to synchronise the remote
control and receiver:
Press and hold in the “reset” button on the
receiver using the point of a pen or paperclip until
you hear a short ‘beep’ followed by a long ‘beep’.
Release the button.
You now have 11 seconds to press the arrow down button on the remote control. Hold the button in
until you hear a short “beep” from the receiver. You will know see the world “conn” on the remote
control. The remote control stops ashing once it is synchronised with the receiver.
