GB-3
Mount the unit so that the control panel is plainly
visible for the driver.
Do not leave it in direct sunlight for long periods
of time.
B. MOUNTING TYPES
We have provided 2 types of mounting methods.
DASHBOARD MOUNTING (Illustration II)
The hook and loop fastener Velcro tape provided,
may be used to mount your detector on a flat dash-
board. The dashboard must be clean and dry for
the fastener to adhere properly.
Remove the backing from the “loop” (fuzzy) piece
and press it firmly to the bottom of your unit.
Clean the dashboard with common rubbing
alcohol to remove dirt and grease.
Peel the backing from the hook side and press the
unit into the desired position on the dashboard.
WINDSHIELD MOUNTING (Illustration III)
Insert the supplied suction cups and cushion into
each slot of the windshield bracket.
Slide the windshield bracket into the groove of
the detector.
Use the Lock button to lock the windshield
bracket.
•
•
•
•
•
•
•
•
•
•
Locate the bracket on a clean windshield and
press firmly on each suction cup.
FOR BEST PERFORMANCE WINDSHIELD
MOUNTING IS RECOMMENDED!
C. POWER CONNECTION
The XT-9500 is designed to operate from the normal
12Volt electrical system and must be used with a
negative ground electrical system. Do not
operate
your XT-9500 on a positive ground electrical
sys-
tem. Consult your vehicle owners’ manual if you
are not certain of its polarity.
After you position and mount the detector, insert
the DC power cable into the jack on the detector’s
side.
Remove the vehicle cigar lighter from its socket
and insert the other end of the power cable into
the lighter socket plug.
For permanent installation, you will have to re-
move the cigar lighter plug, take a 1A-fuse and
connect the cables directly.
•
•
•
•
xt9500.indd 3 15/07/2009 14:11:06
